Catch cans in cold weather

Discussion in 'Mazdaspeed 3 General Discussion' started by daviddnguyen08, May 3, 2016.

Watchers:
9 users.
  1. daviddnguyen08

    daviddnguyen08 Greenie N00B Member

    Joined:
    Feb 20, 2016
    Posts:
    5
    Trophy Points:
    3
    Location:
    Chantilly
    Ratings:
    +1 / -1
    Yeah...I know. It's just about to be summer. But I've been wanting to install an occ for awhile now. Ultimately decided to install that and another can to run a dual setup with the Damond PCV plate once i finally gather the remaining parts to go big turbo. This is my daily, and i only have a power goal of 400hp w/ meth until im ready to start building the block. The only thing stopping me from catch cans is what I read about how the contents in the can freeze in cold climates. I live in VA, so in the winter months, I've seen temperatures go down to the single digits. I've also read of people using catch cans in about the same, if not colder, climates with no issues so long as you empty the can frequently so it doesn't become backed up in the event of freezing. However, unfreezing the contents to empty every week sounds like a PITA but if that's what needs to be done, I'll get used to it. Anybody have any other solutions?

    Also, my tuner is at about the same power level I want to be at. He isn't running any cans but told me that an EGR delete (which I'm doing regardless) and a valve cover breather cap is enough to relieve crank case pressure. I asked him, well what about the blow by? And he said if I'm getting excess blow by which my engine can't burn off, I have bigger problems such as bad rings or ringlands.

    Sent from my SAMSUNG-SM-G900A using Tapatalk
     
    Last edited: May 3, 2016
    daviddnguyen08, via a mobile device, May 3, 2016
    #1
  2. 5doorsoffury

    5doorsoffury Silver Member

    Joined:
    Feb 11, 2016
    Posts:
    203
    Trophy Points:
    43
    Location:
    ny
    Ratings:
    +243 / -9
    If you run the car hard or for a long trip then empty the can it shouldn't be frozen due to the hot gasses/ engine bay. My vacuum can fills 3 times as fast as the wot can.
     
    5doorsoffury, via a mobile device, May 3, 2016
    #2
  3. tarnumf

    tarnumf Greenie Member

    Joined:
    Feb 22, 2016
    Posts:
    87
    Trophy Points:
    18
    Location:
    Boulder, CO
    Ratings:
    +74 / -0
    I never had OCC to freeze in Chicago or Denver weather. My is installed next to the battery. May be it was after sitting in the cold overnight, but who cares, driving the car for like 30 minutes will unfreeze it for sure.
    What was my issue with cold weather is how fast OCC was accumulating the water from vapors, especially while cruising on highways. My old small one required emptying every 200-300 miles. Eventually I made my own from a 3" pipe and just pull the drain every 1000 miles.

    Also, the point to have crankcase vented actively is to get rid of blow by gasses, which otherwise will be absorbed into the oil.
     
    Last edited: May 3, 2016
  4. Quigs

    Quigs Greenie Member

    Joined:
    Feb 10, 2016
    Posts:
    353
    Trophy Points:
    63
    Location:
    Richmond, Virginia
    Ratings:
    +313 / -0
    I'm also in VA and have never had any problems with catch can contents freezing. I empty mine every 2500 miles.
     
  5. Raider

    Raider Administraider Administrator Platinum Member

    Joined:
    Jan 28, 2016
    Posts:
    7,045
    Trophy Points:
    113
    Location:
    Behind a Keyboard wearing full body armor
    Ratings:
    +8,148 / -12
    Grab hose, run from throttle body coolant hose, wrap around OCC, back to throttle body. Use coolant to heat it.
     
    Raider, via an iPhone, May 3, 2016
    #5
    • Like Like x 3
  6. Gandalf

    Gandalf Greenie Member

    Joined:
    Feb 10, 2016
    Posts:
    320
    Trophy Points:
    63
    Location:
    Bowling Green KY
    Ratings:
    +457 / -3
    Most of the time when people have freeze issues with cans it's not the can that freezes. Often cans get installed with too much hose which can dip below the the PCV plate and back up to the can. Condensation along with water gunk can build up in the low point and freeze blocking flow, which is bad.

    My closed can is lower than the PCV plate with a straight hose, no dips. My vented can is higher than the PCV plate and is also straight.
    Make sure there aren't any dips in your hoses. That said, my car sits in a toasty garage when the temps dip really low. Have daily beater.
     
    • Like Like x 1
  7. 5doorsoffury

    5doorsoffury Silver Member

    Joined:
    Feb 11, 2016
    Posts:
    203
    Trophy Points:
    43
    Location:
    ny
    Ratings:
    +243 / -9
    Raider's post is the best " im worried about my catch can freezing" solution. You can also put a bypass valve for the warmer weather so you don't heat the can when you don't want to. This is what i will be doing with my build.
     
    5doorsoffury, via a mobile device, May 3, 2016
    #7
    • Like Like x 2
  8. Gandalf

    Gandalf Greenie Member

    Joined:
    Feb 10, 2016
    Posts:
    320
    Trophy Points:
    63
    Location:
    Bowling Green KY
    Ratings:
    +457 / -3
    If the hose freezes, heating the can won't help. Also if the car sits two days in very cold temp without staring engine , won't help. Some will disconnect the hose from the can and let the hose hang low, not environmentally friendly but works.
     
    • Like Like x 1
  9. Gizmo

    Gizmo Good news, everyone! Greenie Member

    Joined:
    Feb 16, 2016
    Posts:
    438
    Trophy Points:
    63
    Location:
    Kanata, Ontario Canada K2L 2Y4
    Ratings:
    +293 / -0
    freezing catch can and lines is one of big reasons i have not gotten a catch can myself. at -22F at night during winter, just about everything will freeze fast at that temp. Some guys have hooked up small heating pads to cans to help thaw them out before driving,and like stated above by Gandalf, water in the lines also becomes a big problem.
     
  10. brainbot1

    brainbot1 Greenie Member

    Joined:
    May 31, 2016
    Posts:
    118
    Trophy Points:
    28
    Location:
    Flemington, New Jersey
    Ratings:
    +47 / -0
    I know this is an old thread but I'm considering the product below. connect the positive to a switched positive so that you can turn the key with the engine off and it would warm the catch can up before starting the engine. I may install their oil pan heater as well for those cold winter mornings then unplug it in the non winter months. They sell various 12V models with varying sizes and power ratings. You could also wire another switch in line with the power switch to turn it off once it gets up to temperature so its not running constantly. And if you were really feeling handy, wire in a thermostat to keep it above a set temperature.

    https://wolverineheater.com/collect...el-filter-heater-12-volts?variant=35118711954
     
    Last edited: Jul 18, 2018
  11. SharksInSpace

    SharksInSpace Planets and shit. Silver Member

    Joined:
    Apr 5, 2016
    Posts:
    1,739
    Trophy Points:
    113
    Location:
    Middle Coast
    Ratings:
    +2,149 / -14
    My can definitely froze this past winter. Not the lines, but the captured water vapor in the can. Talk about a struggle bus when I tried to drain it.
     
    • Like Like x 1
  12. brainbot1

    brainbot1 Greenie Member

    Joined:
    May 31, 2016
    Posts:
    118
    Trophy Points:
    28
    Location:
    Flemington, New Jersey
    Ratings:
    +47 / -0
    what state are you in? how cold was it? How long did the car sit for before starting? was it windy? We had a pretty crazy storm here in NJ this past winter where it was 30+ mph winds with an air temp in the single digits.
     
  13. SharksInSpace

    SharksInSpace Planets and shit. Silver Member

    Joined:
    Apr 5, 2016
    Posts:
    1,739
    Trophy Points:
    113
    Location:
    Middle Coast
    Ratings:
    +2,149 / -14
    I'm in WI. It was cold. I daily drive the car year round. I blasted the can with a heat gun and squeezed on the lines to force it to drain.
     
  14. Gizmo

    Gizmo Good news, everyone! Greenie Member

    Joined:
    Feb 16, 2016
    Posts:
    438
    Trophy Points:
    63
    Location:
    Kanata, Ontario Canada K2L 2Y4
    Ratings:
    +293 / -0
    • Like Like x 1
  15. brainbot1

    brainbot1 Greenie Member

    Joined:
    May 31, 2016
    Posts:
    118
    Trophy Points:
    28
    Location:
    Flemington, New Jersey
    Ratings:
    +47 / -0
    Thanks for the good find. Everyone I know in Canada, Alaska, and Montana (n=3) uses the wolverine brand. They seem to have a good reputation on the internet. I'm going with them.
     
  16. Gizmo

    Gizmo Good news, everyone! Greenie Member

    Joined:
    Feb 16, 2016
    Posts:
    438
    Trophy Points:
    63
    Location:
    Kanata, Ontario Canada K2L 2Y4
    Ratings:
    +293 / -0
    No problem, let us know how it works out.
     
    • Like Like x 1
  17. Solarsurge

    Solarsurge Greenie Member

    Joined:
    Jun 9, 2018
    Posts:
    294
    Trophy Points:
    63
    Location:
    Richmond, VA
    Ratings:
    +350 / -2
    Mine lines AND catch can froze in the sub zero temps New Years Eve in Philadelphia after a 300 mile drive up. I didn't empty the can. Needless to say, I'll never make that mistake again. lol
     
    • Like Like x 1
  18. brainbot1

    brainbot1 Greenie Member

    Joined:
    May 31, 2016
    Posts:
    118
    Trophy Points:
    28
    Location:
    Flemington, New Jersey
    Ratings:
    +47 / -0
    is it safe to say that catch cans need to be emptied more in the winter?

    colder temperatures = decrease in cylinder seal = more blow by?
     
  19. SharksInSpace

    SharksInSpace Planets and shit. Silver Member

    Joined:
    Apr 5, 2016
    Posts:
    1,739
    Trophy Points:
    113
    Location:
    Middle Coast
    Ratings:
    +2,149 / -14
    they catch more water vapor in cold temps.
     
    • Like Like x 1
  20. Solarsurge

    Solarsurge Greenie Member

    Joined:
    Jun 9, 2018
    Posts:
    294
    Trophy Points:
    63
    Location:
    Richmond, VA
    Ratings:
    +350 / -2
    Any moisture in the air condenses on contact with any surface that is cooler than that air, just like a cold beverage sweats on the outside because the warmer air outside hits the container which is cooled by the drink inside it. The same physics apply when hot engine air touch the surfaces of your freezing cold hoses and catch can. While the air is still warm, the water inside won’t freeze. But as soon as you let your car sit and the temps inside that system drop, you get ice where the water used to be collecting.


    Sent from my iPhone using Tapatalk
     
    Solarsurge, via a mobile device, Jul 24, 2018
    #20
    • Like Like x 1
Loading...

Share This Page

Users Viewing Thread (Users: 0, Guests: 0)