Help please, logs included

Discussion in 'Mazdaspeed 3 Troubleshooting' started by gotovato, Jun 7, 2019.

Watchers:
3 users.
  1. gotovato

    gotovato Silver Member

    Joined:
    May 29, 2018
    Posts:
    1,303
    Trophy Points:
    113
    Location:
    Mississauga, Ontario
    Ratings:
    +1,565 / -0
    Hey all, alot of you know my build, pretty simple, but i had the car dropped off to my buddies shop this week for him to install a muffler. The car was on a base map and drove just fine, no issues. when i picked the car up, i flashed the new map from my tuner, went to go wot, and as soon as the car starts to build some boost (like over 5psi) it begins to cut out, pop, shutter, and sound like shit.

    i took some logs and all i can see thats odd is the ignition curve, its adding timing then removing then adding then removing, almost like launch control? all my buddy did was install a muffler, and put the turbo heat shield back on.

    any help would be great, thanks!
     

    Attached Files:

  2. Enki

    Enki Motorhead Platinum Member

    Joined:
    Feb 10, 2016
    Posts:
    2,244
    Trophy Points:
    113
    Location:
    Tucson
    Ratings:
    +3,236 / -3
    Logs don't look readable; what were they taken with? Who is your tuner and what tuning platform are you using?

    Edit: NVM set to unicode instead of utf-8.
     
  3. Enki

    Enki Motorhead Platinum Member

    Joined:
    Feb 10, 2016
    Posts:
    2,244
    Trophy Points:
    113
    Location:
    Tucson
    Ratings:
    +3,236 / -3
    Flash back to your old map and see if it persists. If yes, check grounds and any aux fuel setups you might be running for issues.
    If not, well, your tuner fucked up somewhere.
     
  4. gotovato

    gotovato Silver Member

    Joined:
    May 29, 2018
    Posts:
    1,303
    Trophy Points:
    113
    Location:
    Mississauga, Ontario
    Ratings:
    +1,565 / -0
    Thanks for the input. I should’ve mentioned I did flash back to the other map. same issue. No aux fuel or anything either
     
    gotovato, via an iPhone, Jun 8, 2019
    #4
  5. Sho

    Sho Silver Member

    Joined:
    Feb 10, 2016
    Posts:
    1,388
    Trophy Points:
    113
    Location:
    Louisville, KY
    Ratings:
    +2,986 / -0
    Check the line from pcv to to manifold.
     
    Sho, via a mobile device, Jun 8, 2019
    #5
  6. gotovato

    gotovato Silver Member

    Joined:
    May 29, 2018
    Posts:
    1,303
    Trophy Points:
    113
    Location:
    Mississauga, Ontario
    Ratings:
    +1,565 / -0
    Thanks for the help guys, and guys in shout last night! I just did the plugs and one plug tube was flooded with water. I guess the seal wasn’t great on that coil and the car sat outside in the rain for a week. Dried up the water, changed the plugs, good to go!
     
    gotovato, via an iPhone, Jun 8, 2019
    #6
    • Like Like x 2
Loading...

Share This Page

Users Viewing Thread (Users: 0, Guests: 0)