In my case ( I have a mazdaspeed 6) the ECU is below the steering column, not a big deal to remove it but if your ECU is like the mazdaspeed 3...
Yes I have, it was a bad ECU. found one used from Ebay for 50dlls + 70dlls for the marriage and problem solved. What I did to determine that it...
*SOLVED, it was a faulty ECU, now the car pulls hard, indeed, it was a combination of problems (Bad ECU, oil leak to VVT gear)
I bought another MS6 ECU, i'm gonna report results when swapped and programmed.
Also I ran a cable from ECU pin 4s to the OCV connector negative pin and nothing...
Lucky me I found those pages on a forum, I test one pin that have 12v with a test light ( it turns bright) has enough amperage to move a solenoid....
I will do that. I just test for continuity between OCV connector (both pins) and both of them lands on the same pin of ecu connector. I don't...
Also I test the voltage from the OCV connector and the two cables have 12v, it is not supposed to one be positive and the other one negative?
Hello guys, I need your help, my 2007 MS6 have p0012, the PCM is not sending ground signal to the OCV, if I manually add ground to the valve the...
I have the same problem on my speed 6, ECU no sending ground signal to Ocv, did you find the problem?
*SOLVED* It was the fuel pressure sensor, the one that others say that is compatible with mazdaspeed 3 fuel rail (Bosch 0261545038) for me it...
Thats what I wanted to know, if p0012 is related to HPFP pressure. Car's running great out of boost, fuel demands are met. I compared the HPFP...
Also I did timing chain job I just saw a video from Youtube called ''mazda p0012 CEL DTC cause (for those who tried everthing)'' that basically...
Hello guys, I have a 2007 Mazdaspeed 6 that can't pass hpfp 1487 at WOT, this is what i've done so far to try to fix the problem: *switch the...
Separate names with a comma.