Rgurleyjr's Recent Activity

  1. Rgurleyjr liked mangosmoothie's post in the thread 60-100 times.

    My speed was bolt ons. Stock downpipe, test pipe, intake. Also had a tmic and cbe but they didnt do much, especially on e33 fuel mix....

    Apr 19, 2019 at 9:56 AM
  2. Rgurleyjr replied to the thread 60-100 times.

    Looks like everyone here is past strictly bolt ons. Curious what fully bolted speed will do.

    Apr 18, 2019 at 7:39 PM
  3. Rgurleyjr replied to the thread Low Compression after Injectors Cleaned and Reinstalled.

    If everything was good before this, there has to be a issue with either the injector seals or something else you had to pull off to get...

    Apr 18, 2019 at 6:08 PM
  4. Rgurleyjr replied to the thread Improving efficiency of gen 1 tmic ducting?.

    I have a 3" tmic already. I'm just asking about the ducting going to it. Not interested in a fmic. With my goals and the cost,...

    Apr 17, 2019 at 4:56 PM
  5. Rgurleyjr posted a new thread.

    Improving efficiency of gen 1 tmic ducting?

    Read a thread about a guy who said he put rtv sealant all around the duct on the bottom of the hood. Claimed it reduced bats a little....

    Forum: Mazdaspeed 3 General Discussion

    Apr 17, 2019 at 12:11 PM
  6. Rgurleyjr replied to the thread Problem pumping gas and nozzle shutting off.

    If this happens every time for you, sounds like you have the exact opposite problem as me. I'm not sure exactly what it is but either a...

    Apr 15, 2019 at 5:49 PM
  7. Rgurleyjr replied to the thread How to: Mazdaspeed 3 Clean/Replace EVAP Filter.

    I had originally assumed that number was the part number of the entire filter housing, filter, and pipe assembly. It looked like the...

    Apr 14, 2019 at 4:16 PM
  8. Rgurleyjr replied to the thread How to: Mazdaspeed 3 Clean/Replace EVAP Filter.

    I'll try and get a better picture but it's just under the gas filler door inside the right rear fender well. If you Jack up that side...

    Apr 14, 2019 at 2:43 PM
  9. Rgurleyjr replied to the thread Problem pumping gas and nozzle shutting off.

    Completely removed evap filter, same problem. I was under the car and see the evap canister and the purge valve assembly. I read about...

    Apr 13, 2019 at 3:21 PM
  10. Rgurleyjr posted a new thread.

    How to: Mazdaspeed 3 Clean/Replace EVAP Filter

    So in my quest to try and figure out why my car isn't taking gas at the pump, I decided to start with the so called evap filter. First...

    20190413_092606.jpg 20190413_092723.jpg 20190413_092732.jpg 20190413_092747.jpg

    Forum: Mazdaspeed 3 How-To

    Apr 13, 2019 at 2:24 PM