Well I put a factory clutch in it, it was a superseded number so maybe they changed the pressure plate as well? The mazda dealer I bought it from...
Going to put a new pressure plate and fork and see what happens.
Have not found a solution yet. I didn’t install the clutch backwards, I pulled the tranny back out and everything looks fine.
I checked the movement of the slave, it moves, just doesnt move enough to fully disengage the clutch. with a pry bar i can move the clutch fork...
Just rebuilt my motor, got a new clutch (factory), tob (factory), slave (dorman), master and lines (factory). Put it all back together, bled the...
thanks a lot! she purrs like a kitten now! a very gnarly kitten but she purrrrs
SOLVED::: got a new crankshaft position sensor and it solved all my problems. Is there a way to change the name of the thread so I can put solved...
Cleaned off all the grounds, I think it has something to do with the hpfp. Right now when i try and start it my accessport is telling me im just...
Alright sorry for the late response I haven't driven the car much lately. But I put a optima red top battery in it and it did the same thing....
here is a log of it cranking and failing to start. For some reason I think the battery might have something to do with it. Low voltage can do some...
I just noticed my battery when I turn the car over is at 10 volts.
I think I uploaded my datalog, sorry there's so much info on it I wanted to see everything that was happening. So at first the car starts right...
EGR, tube and everything were clean as a whistle.. this is really starting to frustrate me. Im at a loss!
Very interesting! I will take it off my car tomorrow after work and report back!
Separate names with a comma.