Single mass flywheel

Discussion in 'Mazdaspeed 3 Transmission/Drivetrain' started by superman, May 31, 2017.

?

Did you reuse or replace flywheel bolts?

Poll closed Dec 31, 2017.
  1. Reused

    20.0%
  2. Replaced

    60.0%
  3. new bolts came with my southbend clutch from edge, so my answer is irrelevant.

    20.0%
Watchers:
10 users.
  1. NavysailorMS3

    NavysailorMS3 Greenie Member

    Joined:
    Feb 10, 2016
    Posts:
    794
    Trophy Points:
    93
    Location:
    Riverview, FL
    Ratings:
    +674 / -1
    With a streetlite and yes i replaced the flywheel bolts.
     
  2. modusoperandi

    modusoperandi Greenie Member

    Joined:
    May 19, 2017
    Posts:
    149
    Trophy Points:
    28
    Location:
    SFV, CA
    Ratings:
    +79 / -0
    I've gone with a Luk & Fidanza flywheel combo simply due to me being on a budget when I did the job. Glad that was the case since I had a lot more maintenance to do on the car soon after. Still replace always replace the flywheel bolts since you are already in there to begin with. Also make sure to check your master & slave clutch cylinders just to be sure they're still in good condition. I know that my master clutch cylinder was beginning to show signs of a small leak when I did my clutch so I swapped it out while doing the entire job. Makes it easy when only having to bleed a single time & not multiple times.

    Sent from my Nexus 6 using Tapatalk
     
    modusoperandi, via a mobile device, Jun 2, 2017
    #22
  3. broda

    broda Greenie Member

    Joined:
    Oct 5, 2016
    Posts:
    74
    Trophy Points:
    18
    Location:
    PA
    Ratings:
    +48 / -0
    Really? I have the same setup and it has a decent amount of chatter. Unless if you just mean little compared to the other setup.
     
    broda, via a mobile device, Jun 3, 2017
    #23
  4. BlueSpeed3

    BlueSpeed3 Greenie Member

    Joined:
    Apr 13, 2022
    Posts:
    15
    Trophy Points:
    3
    Location:
    Saskatchewan, Canada
    Ratings:
    +5 / -0
    Is anyone replacing the pressure plate bolts as well or are those reusable? If so what arp# would they be?
     
    BlueSpeed3, via an iPhone, Jun 22, 2022
    #24
Loading...

Share This Page

Users Viewing Thread (Users: 0, Guests: 0)