That exhaust manifold looks horrible. If you're looking for something like that for cheap check out XSPower manifolds. The one I had held up well....
The car sounded like complete shit. I highly advise against it. I don't have any clips but it was loud enough that I got dirty looks, complaints...
I ran a TurboXS exhaust system and down pipe on my MS3 Gen 1 for years without any issues. You'll be fine. I do recommend using their exhaust with...
I haven't been to "Mexico" in a very long time but I have had some interesting races in my day. My 1986 Mitsubishi Starion vs my friends Evo X MR...
Try going down in wire size. It will also help to wire brush the broken bolt as much as possible. Any contamination into the weld will reduce strength
Are you using a small wire? I found that a smaller gauge allows for better penetration into the metal and makes it easier to build up around the...
That port looks good! Did you use a sharpie to mark the port? Try using this stuff. It's a bright blue color and has a brush in the can. You can...
The EGR is shut when the solenoid is off. You want it in a full time vacuum so it pulls the exhaust gasses into the engine. If it was before the...
Ideally you want the EGR to always be in a full vacuum environment. That's why the EGR tube is always behind the throttle plate. You could try...
[IMG]
If it's crap then set one up for Lemons racing. 24 hours of complete beater shit boxes trying to survive lol
Y'all could take all your spare performance parts and make a forum members race car for AutoX or Track days at a yearly forum members meet. Or do...
Yes. The bottom section of the port. Here is a link to an article about porting Miata heads. The same principal applies....
Whatever you do, don't port the floor of the ports. Only do the roof. Porting the floor will change the angle of airflow and can hurt performance...
In all fairness the 3/6 platform is dated. They're going on 20 years old now and the number on the road is getting less every year. It's always a...
What is going to be the next project?
What made you decide to sell it? Everything ok?
Got my rear blocks installed over the weekend. I also installed a new set of speakers in the truck as well. Now I just need to order the lower...
I used Hawk pads and don't recommend them. They were incredibly noisy and wouldn't stay bedded no matter what I tried. I was using them with DBA...
You rotated the camber plate to correct caster angle or did you slot the mounting holes to allow the strut to tilt forward or backwards?
Separate names with a comma.
