A bad crank position sensor will have similar issues, just FYI, Minus the pump not priming. So I'd imagine it's the pump and not the crank sensor
Sounds like a bad fuel pump. It's shutting off once it's hot.
If you're going thru kozmic, you're in good hands. I'd imagine Justin (freektune) has his hand in your tune.
The kozmic dp i have is part of one...
I tune myself. I also have the cs TB lol
This is awesome!
i think im gonna stop right here and just dial in the fuel to get afr flat until i get this car on a dyno. Being on 10mm head studs, TQ needs to...
Working ebcs came in the mail from Eric today...
Lkq stamp on the block. Came from a junkyard, likely out of a wrecked car
What cams you have?
I have none of these issues with an HTP 4" intake with no air straightener and kelford 247-C cams with idle at 1000rpm
Welp, @Awafrican deleted my last 2 posts trying to merge them lol.
So here we go.
Got a fresh log in today on my base map. The ebcs decided to...
It is. The ebcs took a shit, so I'm stuck on spring pressure lol.
Picked the ms6 up on Monday! Lots of varying rpm, engine braking, and spring pressure pulls getting the rings seated.
About 250 miles in so far...
I'll be right around where you were power wise (mid 600ish) since I'm still running 10mm head studs and have to keep tq under 550, so I have hope...
@Littleloogy had a thread on this on msf. Gen 2 specific. Unfortunately can't find it in the archives. I reached out to James on fb to see if he's...
It was a dealer add on for the gen 1.
I had one. It sounded great
Some cooked brake fluid
New to me front bumper (the license plate frame will be removed)
Wotbox is installed
Fuel pressure at idle, if everything is mechanically solid will vary based on ECT. the colder the coolant temp, the higher the idle hpfp pressure
May I ask why you used a felpro head gasket? And not oem or cometic which run $80-90 and are proven to work
A few folks have...
Separate names with a comma.