Welp, I havent driven it at all since that update as the car is on 4 drag radials and its cold and snowy out. So no progress.
I still have to...
I get the rev hang and the jerkiness on decel/engine braking.
For future reference cause I'll lose it otherwise
Misfire. Gotta figure that out
Definitely a 10 footer. Need to buff the entire car and have some PDR done. And then get the rear bumper and spoiler painted
The aeromotive should have more head room.
I was able to do this on an aeromotive stealth 325 (gen 1 pte 5862). But with larger PI injectors. I...
Here ya go. They look similar to the CS seals but are slightly different. And without the exorbitant shipping fees
After i bring it home..gotta install these...and then hope and pray the weather holds up and i can get it...
James pistons are stock bore iirc.
I believe so, unless you call Jordan and do it over the phone
Overspeed motorsports seals paired with a set of freshly cleaned, low mile injectors!
Cp-e safe seals FTL.
All 4 were leaking and 2 were stuck in the head. Thank goodness for pipe extractors. (Thanks @KingScumbag for the tip)...
Traded the stock cbe +200 for a corksport cbe yesterday. Dude drove 7 hours from Eastern PA to do it...wild lol.
In other news, we had...
+1 on that ptfe line. Thats what pat used for my hellcat pump
Not sure tbh.
No one has really run 12:1+ other than enki, & mark (who i bought these pistons off of to get remade).
Marks car was the yellow...
Moreso doing the high comp for transient response with thr 6266 turbo. Not that it spools slow IMO as is ..but it'll light it up quicker
Bearing caps installed today
[ATTACH] [ATTACH] [ATTACH] [ATTACH]
Separate names with a comma.