Where in Flroida are you roughly? Think I found a diagram/part numbers....
Why toss when you can get it fixed?
*not in 5th or 6th gear.
Isnt the shaft unbalanced now? So the bearings will take a beating and the shaft itself (before it goes into the bearing) will see increased...
Front Control arms for MS3 Gen 2, right then left....
The usual gas has up to 10% ethanol. Most people tuning for power on stock fueling go up to e30 or so. You have to flow more volume of ethanol, as...
I was suggesting the addition of ethanol, if you don’t already run some. edit: I believe a gallon or so to a full tank shouldn’t throw off fuel...
Are you running a fuel mix with ethanol? It could eliminate bad fuel as a culprit.
Changing cold start expected ECT (or something) was the way to lower cold start RPMs via tuning.
Enki should feel something when he powerfists it in.
Injector Rx seemed to be the place a few years ago. https://mazdaspeeds.org/index.php?threads/why-you-should-check-your-fuel-injectors.6879/
Remove from engine and send out for flow testing / rework is the normal method.
You might be due for a cleaning on the injectors. Would not be fun to be mid tune on the CST4 (you'll need an AP, or VersaTune too FYI) and need...
What does battery voltage drop to when cranking? EB - why you think new battery bad and not just something choking engine at idle?
Have you tried your basics of cleaning MAF and replacing engine air filter? Could also be a vacuum leak, have you checked for any hoses obviously...
What is your complete mod list? Just the access port?
Wrt the lower washer. The bolt it is common to on the oem manufold is shown on page 10, figure 5c in the link below. If you continue modding,...
When cranking only getting to ~70PSI sounds like just the in tank pump. You should have the HPFP (high pressure fuel pump) bumping that up to the...
I think most of the technical manuals are behind the membership paywall. Dont know if the one you are looking for is there.
I'm not sure, but here are some pics walking through replacing the MS3 transmission mount. You can at least visually verify it'll mount up...
Separate names with a comma.