Did you do a smoke test? I know you said you checked for loose clamps but pressurizing the system and either smoke testing or spraying soapy water...
+1 for terlizziautoconcepts. Pricey but the guy does quality work.
Looks like you have a couple things to work through! If it makes you feel any better, I had an irregular random misfire code that would come and...
If you've confirmed wiring and the injector isn't the issue, i'd move to the coil packs. Try stretching the spring that makes contact with the...
I would just give Corksport a call. I'm sure they have done some R&D and can tell you if PI is possible with a TMIC. It's highly likely that...
I’m bummed I didn’t go this year. I’ve gone every year since 2018 and it’s always been a great time. Looks like a good turn out this year!
Do you have a build thread for the mx-5 swap?
The rattle could be one of the pulleys. I would check the idler pulley as that is a common failure. The low tone with a little bit of a rough...
I was able to find them at ace hardware. I would check your local hardware store.
I would take a different approach than what you’re going for. If you have the turbosmart bov I’m thinking of, it’s like 4 inches tall and is sort...
I used the chemical guys v32 compound with their orange cutting pad followed by the v38 polish with their white finishing pad. I have a torq...
[ATTACH] [ATTACH] Quick Clay bar, compound, and polish. A little bummed the paint is faded and won’t be getting rid of the old emblem shadowing....
Speed performance sells brass shift fork replacements. Much better than the plastic oem ones....
This thread does not help my urge to buy another Miata
Well it turns out the temp sensor I swapped a few months ago was in fact not oem. All of my issues and codes (P0126 & P0118) have gone away after...
It’s not very often you see a chassis in the back of a pick up truck haha
Yes I forgot to mention I replaced the the thermostat and ect sensor at the same time. Both were oem from what I can remember. However I did go...
Small update: Last week I took a look around for any pinched or stretched wiring. I checked the ecu pins and wiped out all of the surrounding...
Ah I didn’t consider the harness. I have noticed it is pretty crusty in some spots. I may end up grabbing a new anyway. I did not remove the ecu...
I’ll start by mentioning that i had the car apart for an injector swap with overspeed seals, added a perm pcv plate, new oem pcv valve, and a cs...
Separate names with a comma.