I believe the technical term is "letting the smoke out". Definitely an odd failure mode. If nothing looks super melted I'd try to mend it.
Oorr you could make it MORE complicated and swap to an early K series throttle that's an electrical motor controlled cable throttle...
When you step into the world of competition being a better driver only takes you so far, for any given class for Global Time Attack and Gridlife,...
I don't follow NA FF all too much but from what I've seen the K24 stuff seems to be pretty popular nowadays over in JP. Maybe you aren't...
Responses in blue!
The Ferrea stuff is certainly high quality. I wouldn't say you need the springs before getting the head work done or vice versa. Just be sure to...
The coil bind measurement is referencing the spring height at coil bind. The measurements directly relate to each other (15mm max lift results in...
They're both good and they both suck. At the end of the day most valvetrain failures are because people slapped shit together and didn't actually...
Yea you're mostly likely fine. 2 teeth isn't a whole ton.
How far did it slip? Usually you can get 5-10 degrees before there's any interference. On some motors if your pistons have large enough valve...
Dang, at least it's nothing super serious that requires pulling the engine or trans tho.
I'm gonna ask the real question on everybody's mind: Will It Blend?
Mine is a first gen so the turbos are replaced by two more cylinders but I daily mine as well. No complaints other than be sketched to enter some...
Nudes? Also 6 thou is definitely too much to seal but there's enough meat to have it machined straight again
What about trucks? Lol
Was a room sharing thread ever made?
Nooooooooooo. I'm still planning on it!
So when is this car gonna get sent??
Lol ;)
Things have been super slow and I'm itching to get back out on track. Should be able to get back out there in two or three weeks so looking...
Separate names with a comma.