More accurately: "installed a 3.5 bar to replace the failed 4 bar". Don't want anyone thinking I didn't have that covered.
Yeah yeah, ruckus from the peanut gallery. The next project is a '51 mercury chop top to build with my son.
As eventually happens with all of us, the Mazda is going away. Nope, nothing wrong, not a fit of rage or anything like that. Historically I seem...
I own a V3 guardian angel. It´s done its job plenty of times....until now. The internal map sensor took a shit. I emailed Stratified to ask if it...
Alcohol doesn't freeze, my man. Send it. Also, answered most of your questions in a PM to not further hijack the thread :smile:
That's 100% true. 25psi on a K04 is a lot different from 25psi on a 6062! 5th/6th port setups are easy enough and convenient and are an answer...
40K miles on the mahle 4032 pistons here. Not an issue at currently 33psi and what some might call a lot of methanol. Stock cams at just a tick...
once the EGR is out of the way the K04 has room to come through the space it leaves without removing the exhaust manifold. Of course once you`re...
The S4 is a great turbo but may be a little bit bigger than you`d want for a stock replacement feel. It`s sort of a dialed down 3076. Spool is...
After doing the forged build route on my Speed 3 with what some would say has been good results for a DD I have this perspective on it: If you...
A week and 600 miles later, here is the "it`s broken in" update. I went and re-bled the system again and the clutch feels almost like a normal...
Ah man, it`s not as fancy as it sounds. It was actually a really shitty curve that fell on it`s face at 5500rpm. I think peak HP at that point was...
FWIW I put 546ft/lbs of torque into my FX400. It`ll hold pretty much anything a street driven car will put it through :)
I`ll just get to it. I`ve been using ClutchMasters products for 20ish years. Multiple platforms of vehicles, so when I built the engine in my...
So it`s literally brand new, hardly 25 miles on it, but the FX350 is so far a grabby beast. Grabbier even than the ceramic FX400 it replaced. It...
Took a while to get the ducks in a row but the new clutch showed up today. I am proud to also say that I have a fledgling sponsorship deal with...
Provided the build is good, the only real "break in" is getting the rings seated. Bearings don`t break in, per se, and camshaft technology has...
I`m pretty sure my calibration is off but since I got the new tires it`s only about 2bd louder at 70 than it is at idle. I may get froggy and do a...
No changes to follow up with, per se. Upped the methanol system and kept blowing the feed lines so I built a quasi-fuel rail setup for it. Not on...
Between work and just personal driving I put between 500 and 1K miles a week on my built motor BT DD Speed 3. Almost 30K miles on it and not a...
Separate names with a comma.