Check this out. It might help just to make sure you didn't miss anything....
So a few weeks ago while the car was warming up it started to stutter then stalled, started again and immediate stall. I decided to re-flash the...
I had the same issue after installing a CST4, oil dripping onto the downpipe. The tapped holes in the turbo are not deep enough to accommodate the...
I fixed the problem buying a new long block and installing it. But then again you would have known that if you had actually read the entire thread.
I actually did not buy a built motor. My problem was I didn't have a core to send him because my core was unusable due the sleeve inside cylinder...
Jordan from Overspeed Motorsports was a rockstar with his customer service when I bought a motor through him.
There is a one year warranty.
I got it through Jordan at Overspeed Motorsports in New Orleans. Nice guy. He actually talked me out of buying a built motor seeings that my...
The head is definitely usable. You would need to do a little machining to get rid of the pitting around the valves from the little pieces that...
Not sure if anyone has seen this happen to our motors yet, but there you have it. The sleeve in the cylinder broke up. So now I’ll probably be...
Yeah I'm still trying to figure out where they came from in the first place. I checked the turbo and all seems to be good. I think once I get the...
Sooooo. Looked inside the cylinders with the boroscope and found some awful little bits, see picture below. These were on top of the piston in #1...
I have owned the car since 2012, bought it with 92k miles on it. I'm the 3rd owner.
I'm definitely a little perplexed on how that could happen to the spark plug as well. Boroscope & leak down is the next step. We'll see what happens.
I've got a friend who has one so that's the next step.
I'm pretty sure that nothing got in the injector hole when replacing as they were taped off right after pulling the injectors. It does appear...
Replaced the plug. I'm going to borrow a boroscope from a friend to look inside. I did not think it was wise to increase the rpm from idle...
Greetings, So I have had this issue once about 6 mos. ago with a bad misfire in cylinder 3. Tore everything down pulled the injectors as I...
FWIW. I ordered my slave cylinder from Tasca part # B37F-41-920B and had no fitment issues installing on my 2008 Gen One.
If it's leaking on the ground under the front of your car, it's more than likely your slave cylinder. It's a cheap fix and only took about 15...
Separate names with a comma.