No Dave and I doubt that's the reason there is no Mazdaspeed3 right now. If it was, why is there a Civic Si? Ever been to that forum?
Just in case this came back for you.... https://mazdaspeeds.org/index.php?threads/p0301-and-p0300-solution.5928/
So, while I was trying to correct my loss of fuel in this thread https://mazdaspeeds.org/index.php?threads/fuel-pressure-drops-then-stalls.5606/ I...
60 posts is hard though!
Needs a MAF cal for sure but I am not willing to redline it on a VVT/TC that has 226k miles on it. :) Running the CS SRI.
This was last night before I did any work on it
One is coasting, the other was a quick wot on a short road. No sign of the CEL coming back since.
Ya know, I wanted to stop by and say hi last week. Unfortunately, some dipshit in Atlanta thought I needed to stay there until after 9pm....
Can I be the poster child? 226k miles and I will not let her die. Still contemplating new motor or replacing original timing chain and vvt but...
I can't tell you how good it felt to actually drive my car again. So, ran a new 14a wire from the 30a Fuel Pump fuse post to a T connector I...
Resistance. Seems high, especially since one wire shows no resistance at all.
Done, Bisch!!@! Resistance test results show resistance on one side of the resistors plug to the relays. This is without the resistor inline.
Going to spray down with bleach and ammonia then blast it out with the power washer. @Raider why am I still a Greenie?
We may have found the culprit. This us inside the fuse box. Mouse nest. From one of the resistors wires, I get continuity to both the battery post...
The new resistor has continuity and the resistance is in range. That said, at the advice of another local, I'm going to jump the resistors plug...
New development. So, all those new parts and maybe I did or maybe I did not test jumping the fuel pump circuit relay again but we did today and...
No. Any reason I should suspect it?
I haven't had a chance to do too much lately but here is a log of it idling til it stalls.
I tried it on the circuit relay and then the fp relay - same result. Still no codes.
It starts to go down before it dies.
Separate names with a comma.