I'm looking into doing something that hasn't been done yet. But need someone or a few people that have very in depth knowledge about the speed 3...
.
Sorry bro. Life got hectic so car was on back burner. Finally about to start work on her again. When I say the motor died. I didn't mean...
Ok thanks I appreciate the advice im doing a leak down as soon as I get a chance
My bad bro. Ask for help here and didnt get but one response so I figured the people the was following my build would help so I posted it on the...
Well I guess I made a huge mistake. I didn't cure the blow by or high crank case pressure fast enough and the car has power loss... really could...
It ran after the roll over on di 91 tune no problems. No smoke showed no knock at idle couldn't drive it until I got new chassis. Then in new...
-Overspeed Built Motor(Built For 700hp) -Grimmspeed Ebcs -Guardian Angel -HTP 3.5" Intake W/Recirculation Tube (Recirculation Tube Blocked) -4" to...
Update... Well I'm back on my feet, recovered with full range of motion! I'm just thankful it wasn't much much worse!! I'm a impatient kinda...
Thanks Man! Me Too!!! My Baby Stayed Together Rather Well!!! And didn't catch on fire evan tho the fuel pressure regulator snapped off the PI...
Thanks Bro. I'm actually doing alot better so far... alot less pain and capable of more movement... I'm going to hire a lawyer to fight this..
Thanks Bro... As soon as I can walk and bend with no pain. I'm going into over drive to get everything switched back to original speed. So I can...
BAD NEWS--- HUGE ACCIDENT! So Wednesday morning I was driving to work and i was doing 75 to 80mph on hwy 287 in colorado. Speed limit was 65. And...
Update. So I bought new torque wrench and new injector seals. I decided to just replace all injector seals as a set. I made the mistake of...
Well the car drove great that night!! The next day I had to go on a drive after work and was getting on it and enjoying the car finally!!! And It...
Well I re gapped plugs to .022 and changed the plugs, I drained the OCC and I removed the quick drain plug and added a 90° and a hose to it to be...
Ok thanks, Next log I will see if I can see the requested timing.. I sent off the new logs to Justin. so in a week we will see what he says. So...
So tomorrow I'm going to try a few things. Check torque on pcv plate, injectors, st manifold, and check pcv hose to mani. I'm also going to test...
I'll check the torque on the injectors and since I'll have to remove manifold I have a look at the pcv hose. Thanks
Well I changed the plugs and set gap to .018 and it didn't fix it. I can drive in vacuum and it only does the pop and (what feels like a mis...
Separate names with a comma.