This is good info, thank you for your reply. However in my case the case was different. I'm at the 3rd engine after that event, and none prior or...
This person is correct. #3 fails because of the exhaust manifold, not because of the intake manifold. Now you can tell your tuner, whoever that...
Ok, in case there are still people self-tuning around here and they have a 4BAR Bosch MAP sensor (281002576) here are the values I calculated...
60-100mph (96-161Kmph) 3.703s. Modifications at that time: built engine with 4032 Custom SP63 Mahle pistons stock 87.5mm bore, GTX3071R gen1, CP-e...
Ok, since as far as I'm concerned I'm the ZZB uncrowned king (6) I wonder if with with this new engine I'm building I'd use I should use an OEM...
If you want to command AFRs leaner than 1Lambda you will have to disconnect the secondary O2 sensor. And of course disable DCTs for the secondary O2.
No, there isn't, that would have to go into the ABS control module as well and VT only handles ECU stuff. Indeed, but the accuracy is decent and...
Ok, the speedo displays the readings via whatever the ABS module reports, so there is no influence at all from the gear ratios in the tune. It...
How did you alter the MAF cal compared to your pump gas reference tune?
Has anyone played with the gear ratios in the tune? What I'm trying to accomplish is to bring the speedo closer to the GPS readings but I don't...
Make sure you turn the traction control off when going WOT in the first 3 gears. I target no more than 1.6 load in 1st because FWD FTW! I see you...
Does anyone know if when acquired new these heads come with all required parts? I see that on some web shops they come without the camshafts and...
Yes, you can change a tune and only add the EBCS settings.
100% turbo.
If the engine is stock then the only real difference between gen1/BK and gen2/BL engines are the pistons. BKs may also have upgraded valve covers,...
Any pf these, Versatuner or Mazdaedit, can manipulate the factory calibration tables. This is all you need to tune for a larger turbo, for aux...
Nope, the spark plugs were fine (all sets purchased from Edge). There's something going on with the head in my case, some vibration probably from...
Ok, I did not have the balls to go with the Supertech pistons. I acquired another set of Mahle from SP63 and they came packaged impeccably this time.
So initially the spark plugs were tightened in this engine by the Mazda mechanic who built my engine using a torque wrench. Or all 3 of them...
Ok, reviving old thread. I need to rebuild the engine again. No one using the Supertech pistons?
Separate names with a comma.