Can you temporarily swap the ECU, unmarry the accessport, then swap your ECU back in? You wouldn't need to start the car to unmarry it.
Here’s the rattle noise. Sounds disgusting
I’m referring to LTFT + STFT. It’s a gen one. A valve was burnt before the rebuild so it’s possible this was a problem before.
Also - the injectors have never been serviced.
It's the base high flow down pipe tune from VersaTune. The MAF is calibrated for the correct intake :). Also, I know much more about software...
Hello everyone, I need advice on how to troubleshoot a problem with fuel trims. At idle, the fuel trim drops to nearly -20. Under light load, it...
Dev here. Life got in the way and I've had no time or motivation to continue working on it. I just finished building my engine and I'm still...
The wheel speed sensor data is handled by the ABS module which is likely sending the CAN frame with vehicle speed to the instrument cluster and...
Gear ratios: [ATTACH] I also found a scalar related to the vehicle speed sensor (706.4 on speed6?) that needs further analysis.
The UI is in a better state now and there's 300+ tables and axes that need to be identified. If any tuners want to help identify them, lmk....
I've been sitting on this for a few weeks but finally got around to ironing out the major bugs today. OBDLink SX support has been added and should...
Unfortunately OBDLink and ELM-based cables aren't supported at the moment. It's up on the list of priorities as soon as I get one.
Everything helps! If you have a PassThru cable, unzip this archive...
Thta'd be great! If you have the cable, before you try downloading you might want to go plug it in to your computer and open LibreTuner. I was...
I published v0.0.2 which includes a new definition for VersaTune. You will need to select "Mazdaspeed6 - VersaTune" on setup.
The download will fail if the authentication key has been modified from stock, which both AP and VersaTune do. If it becomes an issue that no one...
Yes, that cable will work but I have not tested it myself.
The release of LibreTuner is coming up close, but I need more calbrations. Currently, I have only added support for one speed6 calibration. Edit...
Separate names with a comma.
