Do you have FP prime power at the in tank fuel pump? Test light should kick on, then turn off Also, check the ENG fuse in the interior fuse...
Do you have any before/after specs? Kinda curious on this as I've done this multiple times with very little effect.
If you had more than one low cylinder I wouldn't put my money on this method or a severely low cylinder. Knowing the owner of this MS6 before...
We used to free up rings on GM northstar vehicles weekly with this method from oil consumption/low comp. I figured what the hell, mind as well try...
Nice #'s ken. I'll be out at gingerman cheering you on. Just look for the dude in a speedo hahaha.
Thanks for the tools man. This is a perfect fit for an on car VVT job. These will save alot of time at work. For all you eastern MI folk, I have...
There is no torque spec for the fuel rail sensor as it comes from the factory with the fuel rail. They are considered a one time use upon...
I use a snap on kit. Comes with everything you need. If you've never done this, I'd suggest getting ahold of someone who does. The cut has to be...
Just cut the end line off and re-flare it. You can slowly bend the line out and make a tool fit. Just dont kink it. Replacing lines aren't that...
I can do it! You've hooked me up with some stuff. That is plenty for me. So let me know when its going down.
We can do it at your hose. Free x100 for what you've done for me. We can also run a whole new line if you want too.
The one where the nut stripped?
Separate names with a comma.