Hey all, has anyone else had this issue? Infotainment screen was on and working fine, stopped for gas and shut the car off and once I restarted...
Just an update. Went through over the weekend and double checked all bolts to retorqued if needed. Front end links were a tad loose. All is well...
Stock rears and got some whiteline adjustables for up front and have them set to about the length of the e46 m3 links most use.
More of a clunking, which leads me to think it's time to retighten the end links. Hard to say really what else i hear. It's obviously got some...
Sorry I keep bugging you @Mauro_Penguin lol! But you're one of the only people I know if running the same setup as me. Do you notice a decent bit...
Pardon my ignorance, but replacing springs on this setup.... What size springs are needed and where do you typically go for them. For future...
Got it. Finally got everything buttoned up and done this weekend. Got ride height set and my adjustable end links on. Feels great so far. Ready...
@Mauro_Penguin , one last question I thought of. On the front KW shock, there was a small metal washer at the top of the shaft. I ditched this as...
I appreciate your honesty on my setup. I ended up with the KWs because I got them for all of $900 from KW during a sale. I'm sure there will be a...
Ok, thanks for the info. I'll give the vice/rag tip a try as I've received that advice from a couple others too. And I did remember your comments...
Hey @Mauro_Penguin , when installing the KWs with the corksport camber plates, how were you able to tighten the pillow ball nut enough? The shock...
I'm installing my KW V3 coils this weekend paired up with Corksport Camber plates and SPC rear camber arms. I'm trying to get a feel for what...
You sir, are a gentleman and a scholar. Thank you! Been trying to figure out what the shit I'm going to need for this all over the place. So if...
Coilovers and the Corksport Camber plates, and from what I can tell I need to use the stock bushing, right? Or is there more that gets used from...
Bumping this thread. I've got a set of KW V3's sitting in my garage and plan on using CS camber plates. Can ya'll post pics of how they should be...
Separate names with a comma.
