Well I guess I'll throw a few zip ties on later this week when I continue making ducting for my FMIC. Thank you
@Kwambe Wright , thank you for that information. I've already gone through the headache of installation with a vacuum cap. Sounds like I should...
@Mauro_Penguin you're totally fine dude, I was actually able to figure out the problem. I also noticed that while tightening down each of the...
@mangosmoothie , are you able to elaborate a little more on what port was leaking? I just finished up my CTS4 install a few weeks ago
The one piece version on my GenJuan is absolutely amazing and has been well used
Yes, the 2 bolts for the turbo are smaller in length than the bolts going into the block. I've made sure not to mix them up each time I...
I did a little bit of digging after work last night, and figure out that the upper and lower gaskets have 2 different part numbers. I haven't been...
I removed the gasket remanence from the drain tube last night, it should be noted that the left over gasket could probably have fit inside the...
I reused the OEM oil drain line as I was sort of assuming that it'd be fine in this case. I installed the turbo last weekend (6/18 - 6/19),...
Year: 2009 Make: Mazda Model Mazdaspeed3 Mileage: 188239 DTC: N/A Modifications: See Signature + CTS4 ECU/Tuning Software: Accesport Tuner:...
Oh my, you are super lucky. I took my 10 minutes to figure out how that whole pivot shaft assembly went back together when I was doing mine a few...
Not to throw this thread off or anything, but Tool is really good. On another note, I had to do my wheel bearing too and it went off w/ out a...
I'm sorry to hear that man. The camry sounds sick af though
You might also want to do a little more research about spark plug gap, or someone can chime in about that.
You're going to want to take the spark plugs out, but not before you go back to O'Reilys and get yourself some sort of spark plug measuring device...
Ya that sort of adds up
ah, thank you for the correction. That makes a little more sense. Did anything ever come of the CTSV brake endevours?
I know our calipers say FordMotoCo on the backs of them, but if my memory serves me correctly, there was a large thread on the old forums about...
On regards to E-Tuning, I'm sitting at 181k miles on a stock motor with a highflow cat and all the proper supporting mods. I'm currently tuned by...
While on my commute to work a week ago (6/21), I came to a stop at a stop light and watched as I slight mist of blue/white smoke started to catch...
Separate names with a comma.