I've said it before but I'll say it again. Someone should hook up a 3 wire potentiometer inline with the signal wire for the sender. Then measure...
I meant use a tube with those bearing/race installer tool. I have a ball joint installation kit which has tubes and cups. I use the bearing and...
That's crazy. I've put in a ton of output seals and have never run into an issue like that unless you're using something the wrong way. Try...
If the kid wants to watch Bluey then they'll do what they're told. No TV time until the car runs.
Looks like mint
Have you adjusted WGDC at the same time as VVT adjustments? Have you changed any boost target levels?
Lol you can buy adapters
This might come in handy or you can make your own Melling Pre-Lube Engine Oiler Tool https://a.co/d/1H0xuT2
Is the plunger/roller there for the HPFP? If it isn't then nothing is going to be hitting the valve to generate pressure in the HPFP. It's a...
I'm still following this. I like seeing the progress you've made. I used to do the same thing you're doing with building an engine or transmission...
Is the turbo IWG or EWG? Have you checked for cracks in the turbine housing near the WG swing valve where it seals to the housing if it's IWG?...
All voltage in a circuit should equal zero when a load is applied. IE if you did a voltage drop test with a bulb illuminated testing between the +...
I'm pretty sure I made a post a while ago that has a list of codes for the head units to unlock more options
On my old unit I had to move connections around as there were extra plugs for the Bose or non Bose options. Maybe yours is similar?
I took am wanting to see dyno numbers.
There's two reasons the lights came on. 1.) You disconnected a sensor so it set a DTC 2.) You pulled the fuse for the ABS module causing a break...
Good stuff! The hood vents do make a difference. You might not be able to tell being that summer is basically over.
Are you sure you want to reuse the flywheel? If it chipped in the first place then it could be a defective ring gear in terms of metal casting....
Does he have any experience with HPTuners and Megasquirt?
I'm not sure why you did this but to each their own. I would suggest elongating the pipe out of the bumper. Even with the plate on the outside of...
Separate names with a comma.