Yeah, the car basically stays in closed loop -- looks like it switched to open loop at 4800rpm then afr went from .88 to .71 by 5800 rpm. Looks...
I just did a 3rd gear pull. Same virtual dyno settings on my BNR S4 made 388hp and 252hp on my previous K04 car. This car is so weird that no...
I can log with my HP tuner. Its possible that stock tune and stock power is just so far below what im used to... When you go quarter throttle you...
I just got a mazdaspeed 6 on trade and it idles / drives perfect. no misfire, no hesistation or stutter just is missing some power. I logged a...
oh, so people zero it out if they have aftermarket cams?
It still baffles me that you can reach 500whp on 93 octane and i cant reach 400 on E30 with a lot more timing headroom. Is there any reason to...
I have been searching and trying to absorb all the shared knowledge, but i havent seen many people talk about this topic. I was following thread...
Ive been assuming a vacuum leak. Was going to test it, but been busy. I checked over all the connections and clamps. Did a few more logs and it...
I have spent a good 4-5 hours now googling map sensor issues and not seeing anything related to my issue. November I blew up my winter beater...
I thought it was common knowledge our fuel systems when healthy were maxed at 380whp. I also assumed that was MS3 380whp and not AWHP. I am on a...
i have 171k miles. virtual dyno has me at 410hp with decent weather. I would not trust a local shop unless they specialize in MZR. If your...
with an intake and muffler delete I had my MS6 at 252hp on virtual dyno. I was running E30 with 16 degrees of timing advance at 6,000rpm. 11.7...
I bought an MS6 with 150k miles, on the test drive i heard a rattle like you described. I figured it was a loose heat shield or something. After...
I fixed a huge intake leak, and an exhaust leak. turbo spools better now. Holds PSI to redline, hits my Load targets of 2.7. I just logged...
I have had 3 mildly tuned mazdaspeed 6s and i can say with authority they are pretty slow stock for the average driver. There is a combination of...
I just swapped my stock BOV for a go fast bits unit. no other changes, logged 380hp on virtual dyno this morning, tip in throttle feels much...
I'm at the track now. 13.6@102. 200 degree bats 93f ambient. Waiting in line sucks. Log shows 0 degree timing advance 315g sec
The setup i have now, made the K04 feel very responsive. I just wanted to make sure my spool up is optimized, perhaps when my XS manifold shows...
Dang, i was fully prepared for wizards to come in here and be like "retard timing at load x and add fuel, then adjust VVT yell yaba dabba do!"...
I don't remember logging this, but i am looking at one right now where i started at 2400rpm. I see 1psi at 2634 2psi at 2700. looks like it...
Separate names with a comma.