So I checked out the sensor yesterday as it's the new 1 I just installed but it started throwing me into limp mode again. As far as the moisture...
I can't be the only 1 that's thought of doing this. Honestly just looking for information or a schematic so I can rewire the harness
Hey guys, say what you will but I refuse to buy $400-500 headlights just because they swivel when you turn. Has anybody had any success with going...
If the weather wasn't so shit I'd take the throttle body off and inspect the manifold but I don't think I'm running TOO dirty post turbo. Stock...
Hey guys, been a while since I've visited. Here due to more issues with my MAP sensor. I can't seem to keep them around very long. Just like my...
I didn't just hit "I'm feeling lucky" in my Google search. I've got my VT set up for a Bosch 3bar sensor. So I started noticing some of the same...
Haven't adjusted quite yet, still gathering info on whether it's even worth putting time into and taking to my tuner about it. But if it ends up...
I get that, but my question more so boils down to, what's the difference between a 3bar Bosch for Mazda and a 3bar Bosch for gm if it fits the...
Hey guys, so I'm scratching my head on this 1. So I started noticing some similar issues to when my last map went bad; high koeo voltage,...
It's hard to tell whether they were intentionally welded or just rusted into each other through friction over the years. I did buy it from a...
Bet, thanks bub. Here's some horrifying pictures. The first one's the rear pass side after about 3 consecutive hours of torch, chisel, PBlaster...
So I bought an 07 that I thought was pretty sound. Then my wheel bearings started going out. Now I'm here... Turns out they welded the axle nuts...
Well I've kinda stopped the tuning process once I learned about my compression issues. I'm not stupid
Not exactly, do you think I have no more than a week?
Well honestly, with the state of what I've seen from this motor in not really trying to go for much more than stock until I can save up to get...
So I've had luck with using seafoam for cleaning valves in the past. What're your preferences or methods?
Really, I figured Damon would have something
Ya, seals are definitely on the list. Is there a thread on here comparing brands by chance?
Ok so quite a bit has happened as of late, I apologise but I was never good at keeping a diary. SO, my tuning is going well, on my 5th revision so...
My alternator is hella gross. What's the best way to clean it?
Separate names with a comma.