Rgurleyjr what was the cause of your issue.I have the same problem!!!!!!!!
No yet, that is my plan for tomorrow, i hope that is the case because i looked on the workshop manual and the symptoms that i have are not even...
if i do that window doesn't do any further, up or down.
So, I have a 2006 Mazdaspeed 6 and some reason I cannot roll down the rear driver window all way down or up. No matter witch control I used The...
OP what was the final outcome on your issue???????????
I will try that thanks for the help!!
Thx for reply noob question, how do you power bleed the master cylinder? never done it.
I just did a motor swap on my speed6 and y replace clutch with a LUK clutch set, & Slave cylinder. My problem is that when I initially bleed the...
Oh ok I got you.I see the waste gate duty cycle going over 50%+ in a few cells right before the spike. The problem is that old maps that were...
Is not he tune because I switched(3) maps same outcome, and I run that map that you see the log a spring pressure no spike 12.5 psi so is not the...
The boost target is 20psi and I am overboosting to 24psi and it just started a week ago, I switched to a old map that I know as running good 3...
Revviving a old thread!!! I am having a over boost situation during the initial spool. The map commands 20 psi and I am hitting 25+ for a few...
Separate names with a comma.