Ok so now the situation is weird. I went on a drive the other day on a windy/bumpy road. After the drive the noise was completely gone. It took a...
I may have found the issue. A small crack had developed on the driverside powersteering bracket where it bolts into the subframe. This crack is...
That bushing came new with the control arm I changed recently. Everything is torqued in that area to spec as well.
Well I reset the preload on both frotlnt coilovers and gave it one full turn. It appears one coilover wasn't locked completely and the height on...
I have yellowspeed dynamic pro sport coilovers. Does binding mean the coilover is broken? I hear mixed comments about coilover binding.
*UPDATE* Took my car to get an alignment today. The mechanic thinks it's due to the coilover having too much preload and causing it to bind. I...
Hey guys, there's a very loud clunking noise coming from the front driver side of my 2013 mazdaspeed 3. This happens when turning and going...
I was able to get the whole axle out finally. Had to remove a heat shield in order to rotate the bracket to clear the solenoid. Thanks again for...
I'm still running into difficulties when removing this axle. I should only have to remove the bolts and it should slide out however it's running...
Ok that makes sense. So the bracket won't come out vertically. It has to come out horizontally with the shaft when pulling it out of the...
The bracket in the second picture you gave is the one I'm referring to. All bolts have been removed yet it will not come down. Or is it supposed...
Hey guys, I'm in the process of changing my clutch and cannot remove the passenger axle due to the bracket being stuck onto the engine. I removed...
Hey guys here's a final update: car blows cold air now. My high pressure line popped off the other day cause I guess it wasn't completely pushed...
Just verified the AC clutch does work. I applied 12V to the power of it and it engaged properly. I'm just going to replace both AC pressure...
Thanks for the response! The car does start however I'm having a hard time getting the AC relay to work which is why I was suspecting an...
Hey guys just to give you a little update: Tried using a power probe to put 12V into the plug on the compressor to see if it would activate. To my...
I replaced both the high and low AC lines so they shouldn't be clogged. I also did Vacumm the entire system with a similar kit mentioned above...
I'll have to check that out later. Thanks for the info! If the pressure sensor wasn't working would that cause the A/C relay to not work as well?...
I put refrigerant in the lines and according to the pressure guauge it's in the green however the clutch is still not spinning to take in the...
Hey guys so as the title states my A/C clutch is not spinning with the pulley. First off let me state the number of things I have already done to...
Separate names with a comma.