BTW, pointer for anyone following the Corksport valve cleaning guide in the future using that Harbor Freight gun. Even with the "Fine" grain...
Yep that's the plan, not gonna do all this and not change the oil too (also cleaned EGR, manifold, MAP and MAF, throttle body, and replaced PCV...
Not sure I follow, what does doing an oil change have to do with getting B-12 in the cylinder if some leaks past the valves?
Followup on my previous post...so if one of the valves isn't completely closed and some of that B-12 chemtool cleaner leaks down in there, how bad...
That's what I needed, thank you!
That's a good idea. Might be a dumb question but does one 360 degree rotation of the crank equate to a full valve cycle? In other words if the...
Thank you, but I know how to MOVE the valves by turning the crank, my question is how do I know that the valve is completely closed? It's kinda...
I'm doing this solo (unless anyone in the Durham NC area wants to hang out...), and without being able to watch the valves go up and down while...
https://edgeautosport.com/jbr-billet-adjustable-rear-camber-arms-mazdaspeed-3-2007-2013/ Installed these along with coilovers etc. Getting a...
{deleted...can't figure out how to delete post, issue reported incorrectly}
Yeah Yeah after digging around a bit more that's kind of what I was thinking too, thanks
is the movement/noise when I push/pull on the cv axle normal? Is there usually a little bit of play like that?
2008 Mazdaspeed 3 When backing out of the drive, when I hit the brake there is a small clunk coming from the wheel/hub area, then shift into 1st...
I have not done that, honestly haven't done anything as far as "internals" go. Sounds like that may require actually removing the head? Would...
Intermittent misfire on Cyl 1 only, every 100 to 500 miles or so. No drivability issues, pretty rough on cold starts but once it warms up runs...
2008 MS3 Is there somewhere I can find all the good ranges for all the OBD2 data? For example, I know LTFT + STFT should be close to zero, under...
FYI, total success but a SLOOOOW process. Managed to save the stock threads, didn't need to go up a size or anything. Long story short, I started...
Yeah that's pretty much the last resort, gonna try everything to avoid that. I do have time on my side, not a daily driver and in no particular rush.
Update - haven't had much time to work on it but kinda back to square one, the tap extractor thing is too big for the flutes in the chaser, but...
I think the other pic is a better angle, but it is almost perfectly centered so no worries there. And the hole really wasn't all that rusty or...
Separate names with a comma.