No problem at all (also, sorry for the sluggish reply). The part number for the bulbs is: gj6r-61-c95 I wouldn't bother buying them from Mazda,...
Did you actually pull the connector at both ends and test continuity from the connecting side, or did you test from the back-side of one or more...
Thanks for the update. It's worth noting that Tascaparts.com is still selling all the OEM components.
Check the entire intake tract. Start at the MAF housing, and make sure that the silicone couplers are properly attached, not cracked or pinched,...
Adjusting the preload seems like a recipe for disaster. If your car was functioning properly until something happened and you increased preload,...
It appears that nobody actually kept a copy of the how-to for this mod around on here (I did search, and found references, but no actual thread),...
This thread was originally created on MSF by @JDMCRX back in May of 2014. Hey guys thought I would toss up a few pics of the power steering pump...
[ATTACH] Bend other side or rod. [ATTACH] Reattach spring. [ATTACH] Test that handle moves freely and returns to closed position....
This thread was originally posted on MSF back in October of 2012 by @TiGraySpeed6. Your MAP sensor is what the ECU uses to read boost pressure....
This thread was originally created by @SJP0tato on MSF back in September of 2014. On my rear driver's window a few weeks ago, when fully rolled...
This thread was originally created by @jrzy ms6 on MSF back in June of 2012. ok so i noticed trans fluid leaking and traced it to the rubber boot...
This thread was originally created by @GroceryGtr on MSF back in September 2016. Updated 6/7/18 - Added info for an aftermarket shim kit one of...
This thread was originally created by @Axel907 on MSF back in February of 2014. This is my first clutch job so lets see how it goes. Pretty much...
This thread was originally created on MSF by @lilloui05 back in December of 2014. Hello All! I posted a picture of a fix I did to my MS6 shifter...
This thread was originally created back on MSF by @myarbro1 in August of 2014: I recently asked if anyone knew jack about the CV joint on the...
This thread was originally created on MSF by @ciezczak1 back in December of 2013. hey guys this is long overdue been busy with stuff and finally...
This post was originally created by @dooderek back on MSF back in August of 2011: first and fore most, thanks to jordan (keefover) for...
This video was originally created by @dooderek back on MSF in March of 2012: [MEDIA]
This thread was originally created by @dooderek on MSF back in January of 2012: pretty sure its the same for ms3 but i nce bout those pos wagon...
This thread was originally posted on MSF by @dooderek back in July of 2011 *warning* when conducting this how to be VERY careful to inspect your...
Separate names with a comma.