In my case ( I have a mazdaspeed 6) the ECU is below the steering column, not a big deal to remove it but if your ECU is like the mazdaspeed 3...
Yes I have, it was a bad ECU. found one used from Ebay for 50dlls + 70dlls for the marriage and problem solved. What I did to determine that it...
*SOLVED, it was a faulty ECU, now the car pulls hard, indeed, it was a combination of problems (Bad ECU, oil leak to VVT gear)
I bought another MS6 ECU, i'm gonna report results when swapped and programmed.
Also I ran a cable from ECU pin 4s to the OCV connector negative pin and nothing...
Lucky me I found those pages on a forum, I test one pin that have 12v with a test light ( it turns bright) has enough amperage to move a solenoid....
I will do that. I just test for continuity between OCV connector (both pins) and both of them lands on the same pin of ecu connector. I don't...
Also I test the voltage from the OCV connector and the two cables have 12v, it is not supposed to one be positive and the other one negative?
Hello guys, I need your help, my 2007 MS6 have p0012, the PCM is not sending ground signal to the OCV, if I manually add ground to the valve the...
I have the same problem on my speed 6, ECU no sending ground signal to Ocv, did you find the problem?
*SOLVED* It was the fuel pressure sensor, the one that others say that is compatible with mazdaspeed 3 fuel rail (Bosch 0261545038) for me it...
Thats what I wanted to know, if p0012 is related to HPFP pressure. Car's running great out of boost, fuel demands are met. I compared the HPFP...
Also I did timing chain job I just saw a video from Youtube called ''mazda p0012 CEL DTC cause (for those who tried everthing)'' that basically...
Hello guys, I have a 2007 Mazdaspeed 6 that can't pass hpfp 1487 at WOT, this is what i've done so far to try to fix the problem: *switch the...
No cats and custom tune. When I started with this problem it was a coil connector, replaced it and the issue was gone, but now is doing the same.
I'm having the same issue, but for me it only happens after 5k in 2nd and 3rd gear at wot. My car is modded, at first I thought it was a boost...
I have a Tactrix cable from my last Impreza, I will give it a shot to see if it works on Versatuner software and do the log.
Another question, at WOT and at 25psi the AFRs are 9.23 or something like that and then at idle it goes to 14.xx, is this good right? What I mean,...
I'm very positive that it's tuned, the turbo is a CST4 Corksport , and the car has launch control and no lift shiftting, also one day I...
I will download versatune and buy the cable, do you know what cable is it?
Separate names with a comma.