My apologies, I made an assumption. Thanks for the update.
Yup, I posted all the documentation above.... I tried....
There's people that have had the tips fall off. I wouldn't risk running them. I added it to the database in my suggested update, as well as...
Turn it clockwise (in/down etc.) to "hard".
That's exactly it. The tension is too soft and the valve is hanging open causing a massive vac/boost leak. Need to fine tune the valve, on that...
Is it an oem maf sensor? Wiring/plug could also be a factor. So after you got the code you posted earlier you replaced that injector?
It's above, post #5.
What bpv/bov are you running?
He did state "ngk 6510 gapped at .026." in post #3.
The table above is from a stock map file. However the car I tested it on had a custom tune. You got me thinking though, because I know my tables...
FYI there is only a bank 1 (it's an inline 4 cyl). Those first two codes point directly at either a injector not plugged in properly (I've had an...
I'm not the op... But why I question it is because of tables like this one, and how one of my cars also acts koeo(above). [IMG]
You get 76%? As I posted above koeo I get 58%...
No worries, that shows it perfectly. That's in perfect condition, that actuator is good.
Arp 2000 have less clamping force than oem bolts, so if that's what you are referring to, don't buy them. Sho is the right person to ask though,...
Yes. The width of the wrist pin end of the rod is too wide to fit into the oem piston. Imo you would have to be crazy to want to use the oem...
Did you inspect the locking pin when you had the vc removed? It's very hard to see in your photo, but it almost looks like it's broken (cap is...
I wasn't 100% sure on the actual tps position koeo, so I went to the car currently in my garage to find out (attached), it's 58% that it'll go to....
Doesn't sound like the typical limp mode which is what I was going for. Like sho said, tps should go to around 76% I suggest you pull the...
Does it feel like the pedal has a massive dead spot? Does it feel choppy instead of a smooth transition?
Separate names with a comma.
