2011 MS3 throwing two codes and traction control light stays on

Discussion in 'Mazdaspeed 3 Troubleshooting' started by Mysicksi, May 2, 2020.

Watchers:
3 users.
  1. Mysicksi

    Mysicksi Greenie N00B Member

    Joined:
    Apr 29, 2020
    Posts:
    1
    Trophy Points:
    1
    Location:
    NY
    Ratings:
    +0 / -0
    Hey all. I recently drove my 2011 MS3 for about 30 minutes with no issues. After I parked it and came back to turn it on, I started to throw two codes, along with the traction control light staying on. The codes are P0098 and P0108.

    Here are the steps I have taken so far
    -Replaced both the IAT and the MAP sensor
    -Reset the ECU by disconnecting the negative battery terminal and pumping the brakes 5 times
    -I tried to clear the codes multiple times with my access port

    Nothing has worked so far. Does anyone have any ideas on what the next steps would be? Thank you.
     
  2. Ssinstaller

    Ssinstaller Greenie Member

    Joined:
    Mar 16, 2017
    Posts:
    129
    Trophy Points:
    28
    Location:
    Nc
    Ratings:
    +88 / -0
    Three unrelated issues at once, with two being circuit high codes.
    I would start by looking for damage/corrosion around the pcm connectors.
     
    Ssinstaller, via a mobile device, May 2, 2020
    #2
  3. TorukNeikea

    TorukNeikea Silver Member

    Joined:
    Nov 10, 2023
    Posts:
    10
    Trophy Points:
    3
    Location:
    Texas
    Ratings:
    +11 / -0
    was this issue ever successfully diagnosed? Im having the same problem and cant figure it out, I have already inspected the pcm connectors yet I dont see anything out of the ordinary.
     
Loading...

Share This Page

Users Viewing Thread (Users: 0, Guests: 0)