Accessport v2 Failure at the Pump

So i was just at the pump to throw a little e85 in the tank. I'm on my 93 tune and after the fill-up i went to switch to the e85 tune (i use a 33% mix so this fill-up was 5 gallons e85 and then top off with 93 (8 gallons).

Well as just my luck would have it, my Accessport will no longer talk to the ECU (coms error). I just used it 2 weeks ago to flash the ECU as well as do some monitoring with no issues.

My OBD2 cable has no obvious defects and my Accessport is in good condition.

I drove the car home and popped open the accessport and everything inside looks solid. No corrosion or connection issues.

1. Will i be okay driving on this mix or should i siphon everything?
   
   
2. What could be causing the comms issues? Everything seems good and i was just using it, but obviously failures can happen without warning

 

Could be a simple bad cable. But you will want to get the tune loaded.

 

When i popped open the accessport i "mushed" in the internal connections. Just tried again and i was able to load the tune so it seems like my Accessport is the culprit. Thanks for the quick response!