Help identifying wires

Discussion in 'Mazdaspeed 3 Troubleshooting' started by Rudy Perez, Nov 18, 2022.

Watchers:
1 user.
  1. Rudy Perez

    Rudy Perez Greenie N00B Member

    Joined:
    Nov 18, 2022
    Posts:
    1
    Trophy Points:
    1
    Location:
    Portland
    Ratings:
    +0 / -0
    Hi there, I'm new to the forum and have come here asking for help with my 2012 Mazda 3.
    A few weeks ago I ran into a small pole and damaged a section of the front driver side. I was able to "fix" the bumper, replaced the hood and headlight, plus fixed a few pieces under the hood that were damaged. Luckily this was a low speed crash, so the car is still drivable one thing that was smashed was a connector that had red and white wires attached to it. I think it's part of the CAN bus circuit. If the wires are disconnect the car doesn't turn on. If I connect them it starts right up.

    My problem is that I don't see what the connector that was on the wires plugged into. Not sure if it's missing anything, I didn't see any modules when I picked up the pieces from the accident.

    Any help is greatly appreciated.

    Rudy 20221112_143306.jpg
     
    Rudy Perez, via a mobile device, Nov 18, 2022
    #1
Loading...

Share This Page

Users Viewing Thread (Users: 0, Guests: 0)