Infp won’t prime

I swapped my infp and now it won’t prime but when I hook it to the battery it primes I’m confuse and getting frustrated someone please help


Sent from my iPhone using Tapatalk

 

Why did you swap the ITFP? Have you checked the pump resistor thing in the engine bay on the drivers side near the transmission/headlamp?

 

Had to get a e-85 pump but I have not Is that the little thing that says caution hot?


Sent from my iPhone using Tapatalk

 

should be. youre applying power at the top of the fuel pump assembly right and its kicking on?

 

It’s not kicking on at all and my security light is flashing.


Sent from my iPhone using Tapatalk

 

If your security light is flashing it will disable the fuel pump. Try disconnecting the battery for a few minutes then reconnect. Sounds like it lost its key programming somehow

 

I don’t have the original key that’s the problem I’ve tried that Mazda isn’t any help shits stupid


Sent from my iPhone using Tapatalk

 

Is the key you're trying to use one that has started the car before? If it isnt programmed it wont start the car, you'll have to call a locksmith or take it to the dealer for them to program it

 

This key worked for the past 6 months


Sent from my iPhone using Tapatalk

 

Ok just try disconnecting the battery for 5-10 minutes, then reconnect it and try again. You drove the car before doing the pump correct? Had it been sitting for a while?

 

Yes drove the car then blew vvt so replace a ton of parts and it primed prior to the replacement then it wouldn’t prime so I replaced the pump now the security light is on and and no prime


Sent from my iPhone using Tapatalk

 

Does the car have an aftermarket alarm or remote start?