Get VersaTuner at the BEST price of the year during the VersaTune Black Friday Sale! Get the power, control, and resposniveness that you've...
If you change those two tables reciprocally, they should offset each other in the fuel calc. The load calc does not appear to be affected by the...
Maybe scale MAF down 15% and VE up 15 % See what reported load looks like and if AFRs are close. Or maybe the other way around? MAF up and VE down?
This issue appears to have been related to an engine with a displacement other than 2261cc. The load calculations are based on the engine...
It's the most wonderful time of the year - it's VersaTune Black Friday Sale time! Treat yourself or a friend to a more powerful Mazda this year....
Modify the bcs dc base table downward slightly with a focus around 2500-3000 rpm where the boost will tend to spike on initial spool up.
We published a new tune today to demonstrate the new load axis scaling on G2 MS3. It is for a stock turbo with a CAI and a RP. It has the load...
The rear O2 sensor has minimal input on fuel trims. It is there to determine whether the primary cat is doing its job. When running catless,...
Grimmspeed solenoid in interrupt configuration requires 30% less duty cycle than stock. Use that as a starting point then fine tune from there.
This was a major effort. All of the relevant tables have had axis scaling enabled to allow load > 2.0 You can read more here:...
You need to put your MAP sensor values in 3 places in the tune under the sensor calibration section, then flash the tune. You also need to set...
Separate names with a comma.