Recent Content by Youngwonder

  1. Youngwonder
    Post

    Need clutch. Main concern is pedal feel.

    I have SB S2 and it is pretty heavy pushing down the clutch but spring back strong. For your condition you probably don't want the SB.
    Post by: Youngwonder, Sep 18, 2018 in forum: Mazdaspeed 3 Transmission/Drivetrain
  2. Youngwonder
    Post

    Why You Should Check Your Fuel Injectors

    I sent mine to Injector Rx. They had a quick turnaround.
    Post by: Youngwonder, Aug 23, 2018 in forum: Mazdaspeed 3/6 Fuel, NOS, Meth, & Water Injection
  3. Youngwonder
    Post

    Good Suspension Options?

    I know a while ago the Koni yellow struts with H&R Springs was the go to setup. That's what I have been running for 5 years now. It gives 1.5-2in...
    Post by: Youngwonder, Aug 8, 2018 in forum: Mazdaspeed 3 Suspension & Brakes
  4. Youngwonder
    Post

    Solarsurge's Ongoing 2013 LSM Build

    I tried it doesn't work.
    Post by: Youngwonder, Jul 26, 2018 in forum: Mazdaspeed 3 Build Diaries
  5. Youngwonder
    Post

    Solarsurge's Ongoing 2013 LSM Build

    That was a crisis averted. There could be a chance that you could find someone that buys you car parts for your birthday and Christmas.
    Post by: Youngwonder, Jul 25, 2018 in forum: Mazdaspeed 3 Build Diaries
  6. Youngwonder
    Post

    Slave Cylinder Leak Fix

    I had this issue recently. My issue was I didn't push the rubber grommet all the way on the pipe so it just pushed it in the cylinder and not seal...
    Post by: Youngwonder, Jul 25, 2018 in forum: Mazdaspeed 3 Transmission/Drivetrain
  7. Youngwonder
    Post

    Hello from Richmond VA

    Mine was just rebuilt recently. It felt so good when it started right up. One of our guys has a motor that's been sitting in his shed for about a...
    Post by: Youngwonder, Jun 25, 2018 in forum: New Member Introduction Section
  8. Youngwonder
    Post

    Hello from Richmond VA

    Oh fun stuff.
    Post by: Youngwonder, Jun 21, 2018 in forum: New Member Introduction Section
  9. Youngwonder
    Post

    Hello from Richmond VA

    They repaved it 2 years ago I think. I ran on it once after it was done. It is so much better than it was. When I drag I usually get there about 2...
    Post by: Youngwonder, Jun 14, 2018 in forum: New Member Introduction Section
  10. Youngwonder
    Post

    Hello from Richmond VA

    I'll see if I can drop by Friday night. Depending where yall are doing the install on sat I could drop by for a little.
    Post by: Youngwonder, Jun 14, 2018 in forum: New Member Introduction Section
  11. Youngwonder
    Post

    Hello from Richmond VA

    Sweet, most of us are in Chesterfield. We don't have a silver speed rolling with us yet lol. @Quigs
    Post by: Youngwonder, Jun 13, 2018 in forum: New Member Introduction Section
  12. Youngwonder
    Post

    Hello from Richmond VA

    Welcome. What Part of Richmond? Pics of your car? There is a group of us that hang out pretty regularly. We also regularly go to car shows and...
    Post by: Youngwonder, Jun 13, 2018 in forum: New Member Introduction Section
  13. Youngwonder
    Post

    New Engine VS Rebuild-looking for advice

    If you are pressed for time then I say go with a built engine from one of the shops. They take car of everything and have a warranty. I did a...
    Post by: Youngwonder, Jun 12, 2018 in forum: Mazdaspeed 6 General Discussion
  14. Youngwonder
    Post

    Replacement CV Boot

    I have DTA axle on the driver side. It's been on there for about a year. I have done a few passes drag racing, road course, and aggressive driving...
    Post by: Youngwonder, Mar 31, 2017 in forum: Mazdaspeed 3 Transmission/Drivetrain
  15. Youngwonder
    Post

    Replacement CV Boot

    Interested as well.
    Post by: Youngwonder, Mar 27, 2017 in forum: Mazdaspeed 3 Transmission/Drivetrain