Update- took it to the dealer and they did a internal diagnostic on my cylinder head and found a burnt exhaust valve on cylinder 4, so I’m looking...
Mod list - Corksport Sri Rear resonator delete edit- this is how she is currently running
Oh , I was told by Zach at corksport that the Sri can be installed and run without a tune, I’ve had it on there for about a year now and with or...
I have the corksport sri and it looks like it does have a plastic inner housing around the mass air flow sensor, this one to be exact...
Not yet but what logs do you need I can do readings on my scanner in a moment These are all the stats I can get you guys at the moment my...
Another new coil in number four and she still has a rough idle I’m all out of ideas here guys I could really use some help
Update I started the car this morning and drove her around and she threw a cylinder 4 misfire and a p0300 random misfire on the drive edit- I...
So I unhooked the battery for 20 minutes and started it back up, the idle is still a little rough and when I give it gas it idles up but still a...
And it won’t hurt to drive it while it’s idling rough like this? Like when I push the clutch in it drops to about 300 rpms
After I disconnect the battery should I just start it and let run for awhile?
Cleaned the mass air flow sensor and it’s still running like it has a misfire Edit- fuel pressure at idle is about 700-750 Is there maybe a idle...
Put the valve in today along with new inter cooler boots and new plugs and oil and she is running but with a p0113 code and she sounds like she’s...
Test it like on the vehicle? Of course I’ll make the instal tomorrow I was just confused on the valve because it was mentioned I should be able to...
So I just got the new pressure relief valve in today and I’m checking it to see if I can blow air through it and I can’t blow through this one...
Does anyone have any good write ups on cleaning the spill valve for the hpfp? It’s gonna be two days on the fuel pressure relief valve so I might...
So 15 mins in and I got the pressure release valve out. No coolant lines removed it was a relatively easy removal, now from what I read from you...
So I turned the car on today to try and check fuel trims and it was still misfiring on one cylinder which was number 4. I pulled the plugs out...
When I go to plug in the scan tool and check fuel trims and fuel pressure at idle what numbers should I expect as far as short and long term fuel trim
Ok I will check it soon shouldn’t be to hard to remove, I did however see a video where a guy had to pull hiS coolant hoses off? Is that correct ?
Is it also cleanable? Like does it work the same way as a pcv valve? If I pull it off and test it can I spray it with carb clean?
Separate names with a comma.