The log I posted should have the MAF voltage. That log was taken during said event.
Recently cleaned the MAF, visual inspection of wires seem intact. Further testing suggestions to determine wiring or sensor ?
Hey all, having some issues at idle. I’m attaching a log for reference at idle. Year/Make/Model: 2007 Mazdaspeed 3 Mileage: 122,xxx Location:...
Rgr. I will do that.
Awafrican Looks as if the smoking issue has been resolved. After much discussion and consideration. I pulled all of my charge pipes, cleaned...
Stephen Mcneill Awafrican I’m interested in this as well. I’m having similar issues with idle. I have smoke tested and pressure tested the...
122,xxx
Man, if it’s not one thing it’s another. Oil dripping from the hot side of turbo from that bottom corner bolt. There shouldn’t be oil there…...
I was hoping to catch it soon enough to avoid that by upgrading to the JmF manifold
Cfoldone pulled my restrictor bolt and it’s measuring approximately .066”-.068”… I wonder if I can open that up just a hair Cylinder 3...
Awafrican Enti this is my catch can setup. Pictures aren’t that great. But PCV to can, from can to intake. The line from can to intake manifold...
No sir. The OE manifold was relatively clean from what I can remember. I’m currently at the shop doing some work. I have the intake pipe off and...
Surely hope not because that would void the warranty and when I last spoke with Brian a while back about the turbo, I had told him I had a...
Noted! [emoji1787][emoji23]single best response to-date. Thank you for the laugh. I’ll be in touch!
Rgr. I will do just that. Additionally, there is a check valve in the VTA line before the filter. I made sure of that as not to introduce a vacuum...
I ran the same oil restrictor bolt that I had bought for the K04 when I acquired the car, just used new crush washers that were provided with the...
No, I had acquired the car and it was tuned by Freektune. I had reached out via email and Facebook to get any information about the car, but never...
Combustion leak test is the test to check to see if there is combustion gases in the coolant reservoir tank. Testing to see if there was a head...
Will @ Purple Drank. Nothing has changed, no new modifications since the turbo went in. I’ve changed the oil, found a couple vacuum leaks(MAF...
So, I’ve recently upgraded my Speed3 with the BNRs4, along with JMF manifold, CNT exhaust manifold, DM 3.5” intake, FMIC, has a Tial BOV, and the...
Separate names with a comma.