Does this work on a gen2? My MAF connector is giving me issues so I want to cut it out and solder in a new pigtail.
Had to pull out the whole assembly because it was cracked but yeah if you're only doing master cylinder probably doesn't need to come all the way...
I will check that out after I clean the internals. Are you talking about using the 303-507 pin to replace the sensor?
Having a similar issue, getting really bad hesitation while I give it throttle. No check engine light on, have pte 5858 with supporting mods,...
Yeah I had to put the pedal assembly in place then pull it off the firewall while squeezing the master behind the pedal and through the whole. If...
I think it's a gen 2 thing because there is no way to reach the bolts where the bcm mounts to the pedal from below. Looks like in the other thread...
Yeah looks like you had to cut off where the bcm attached to the pedal.
The center console comes out because it holds on the lower dash panel near the start button in place. Taking out the lower panel makes a lot more...
Got this done and just posted a How-To, check it out guys....
Whats up guys, I was having some shifting and starting issues with my 2012 speed3 and after some inspection I found a decent size crack in my...
Just got the assembly from edge, BBN5-41-300A is the part number which also included a clutch master cylinder, which I had also ordered, so I have...
How did this end up going? I'm about to swap pedal assembly and master cylinder in my gen 2. Sent from my SM-G955U using Tapatalk
The guys @EdgeAutosport.com are hooking me up with a replacement assembly, should be here in about a week. I'll be sure to take some pics for a...
Any idea what part number they used? The number I find is 41-030 which is the pedal assembly but there are still a few different options to choose...
Checked out my neighbors gen 2 pedal and it isn't cracked but moves quite a bit as well. I'll gladly be a tester for a reinforced unit [emoji41]...
Thanks for the heads up. Looks like I need to find an assembly and how to change it out. Sent from my SM-G955U using Tapatalk
You've seen it on a gen 2? Would weldind suffice or you think replace the assembly? All threads I've seen seem the be speed 6s which is why I was...
What's up guys, so the last few nights I have been having a hard time starting my car. I really have to press the clutch pedal to get it to engage...
So I'm looking into getting a fire extinguisher myself, here's why. Had a neighbor move in a couple weeks ago with a gen 2 that had some smoking...
Check pcv valve and hoses Sent from my SM-G955U using Tapatalk
Separate names with a comma.