When I put some oil over the chain before putting the VC back on, is it ok for the VVT actuator and other camshaft sprocket to get oil on them?...
Ok finally got the crank bolt done. No lube this time. When oiling the lifter that goes inside the fuel pump, should I oil the inside of it...
So I tried doing the crank pulley bolt but I think I may have made a mistake somewhere as I was only able to get it to about 30 degrees after the...
Hey sorry to revive an old thread. I noticed when your intake cam is at TDC with the alignment tool in, the top of rightmost lobe (the one that is...
speed 3s power is really addictive, even for a 4-cylinder
Original: Thanks again everybody. Okay so I just replaced the VVT actuator and when I was reinstalling the C.A.P. I was having a hard time getting...
So I shouldn't have the camshaft alignment plate (CAP) in when removing the crank pulley bolt, correct? I'm seeing conflicting advice on this...
Thanks again for all the help especially to the OP. In this thread: https://mazdaspeeds.org/index.php?threads/timing-the-mzr-disi.8722/ He...
Thanks guys. Can I clean it with kerosene or brake parts cleaner?
Is this the cam follower? I'm having a hard time getting it back into the cam housing without touching it too much.
Separate names with a comma.