Issue solved. I still need to do tdc then count 20 teeth..but old sensor was at a spot i could line the new sensor up at basically same spot. The...
Im going to order a tdc peg and do it
Cleaned sensor still no start or signal from the crank sensor. So as assuming its the crank sensor itself that went bad. I would assume they can...
No i just stated that i have not. I will attempt that but i also got a sensor from local parts store
I have had other vehicles where the crank sensor have went bad so i personally know they do go bad. The wiring and plug are all fine looking so i...
Best way to clean it? .. only code it has and cranks with. No start. Injector duty cycle 0 when cranking.
Well i have a crank sensor code and it will crank and no start. So i do need a crank sensor im not just buying something i dont need? Also there...
Im going to get a new crank sensor today and try to get it home. I dont have the tdc peg but i heard you can use a coil pack bolt and then tdc and...
Well earlier it started not going past 3k then sputtered out and wont start now. I hooked it upto a actual good code reader and it says crank...
Damond dual setup with plate ect. Its a full bolt on car besides intake and exhaust manifold still di with a bnr s4 tuned by will at pd.. which is...
08 mazdaspeed 3 Fbo besides manifolds bnr s4 pd tuned Having a weird issue where the car wont go over 4-4500rpm it just hard cuts it runs fine...
Separate names with a comma.
