I have 2007 CX-7 2.3, but same engine... The OCV valve is not working. The valve itself tests OK as does a spare I have. If you run 12v to it, it...
Hi, All good! I cleaned/rebuilt the HPFP with new Viton o-rings and it is working fine. BTW I found in a Corksport pdf for the rebuild that you...
Hi, thanks again for the input. I had a look at the Autotech instructions (I was following the Corksport info). The Autotech instructions shows...
Also forgot to mention that Forscan gives a P0172 code and the CEL is on (which was not the case before the VVT failure). The car has been sitting...
Also when I pulled the pump apart, the shaft with the collett attached came out. Can I reassemble it the way it came out or does the collett need...
OK thanks for the replies. I only have Forscan with an ELM327 USB interface. It reports zero psi in the HP fuel rail...but the car starts and runs...
If I just clean and replace the o-rings and not replace internal parts, should this be enough to fix a low rail pressure?
I have 2007 CX7, but this forum is more active. I have low rail pressure and I think the HPFP may be the problem. If I rebuild/clean it just with...
Separate names with a comma.