Alright I think I'm finished all the way around. Now, it's gotta go to the machine shop for new guides and a valve job for these new supertech...
Exhaust side is 90% complete! Finish up the last little polish touch-up and I can be done with that side![ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH]
Starting to feel a lot better about the exhaust side now. I think I'm actually done removing material now. Think this should allow more total...
Still have quite a bit to do on this head, but I've made some major progress![ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH]...
Got my new 6 puck ACT disk, and have been waiting on the Xtreme pressure plate to show up for a while now. Finally came in, and turns out I have...
Are you upgrading to stiffer springs? If not I doubt there is a reason to change them. Leakdown test to determine if the seals would be necessary...
Supertech valves arrived today! Went +1mm Exhaust in Iconel and std size intake black nitride. Didn't feel like the iconel was necessary on the...
Still not done with porting this head, but all the major material removal is complete. Pictures attached next to an oem head. Need to finish the...
Yeah I actually replaced the full clutch line with a braided stainless line and bled it fully as well. I also do run DOT4 and try to exchange a...
So i got the car to start up and went for less than a 5 mile drive, used the brakes liberally and they felt good. I've been bleeding them with a...
The only light I'm getting is a solid ABS, my check engine flashes but nothing else I noticed. I connected FORSCAN and all the normal codes are...
Been doing a bunch of work to my car, finally got it all together and I have an ABS light on, I assume from changing all 4 calipers and the car...
Freektune FTW pistons are in and look glorious! Now I just need some 12mm head studs so I can send all this stuff off to the machinist!
Kelford C-2 cams showed up! The pieces are all starting to come together!
Separate names with a comma.
