Yea you're mostly likely fine. 2 teeth isn't a whole ton.
How far did it slip? Usually you can get 5-10 degrees before there's any interference. On some motors if your pistons have large enough valve...
Dang, at least it's nothing super serious that requires pulling the engine or trans tho.
I'm gonna ask the real question on everybody's mind: Will It Blend?
Mine is a first gen so the turbos are replaced by two more cylinders but I daily mine as well. No complaints other than be sketched to enter some...
Also 6 thou is definitely too much to seal but there's enough meat to have it machined straight again
What about trucks? Lol
Was a room sharing thread ever made?
Separate names with a comma.