You should check the ground as @Cfoldone mentioned, this stopped my car from starting forever. It is very common to be corroded. Other than...
What about the starter trigger wire? It loves to be corroded and cause starting issues..
I currently have this issue and haven't had a chance to troubleshoot it. But, for me at least, it's probably a gross vacuum leak. My favorite...
Late to the reply, but those two fuses are R.Cigar (15A) and Rear wiper (10A). When I had issues, the one directly above the rear wiper was blown...
Is it cranking? Or is it just clicking? There is an engine ignition fuse in the cabin fuse block under the drivers dash. Think it's a 15amp....
I started a compression test and realized I can't because it won't crank lol. Was pissed once I realized that.
Long story short, I purchased a speed6 as is (not running), put it all together and now it won't start. When I received it, the engine was...
These cars are very sensitive to plug gap it seems. It needs to be 0.025-0.028; never trust the pre-gapped plugs either. What is your HPFP...
Why not just wire it to a switched source then? I've been running a dvc30 stage 2 for around 2 maybe 3 years without issue (minus the nylon line...
Here is a log I did before and after the coolant bypass. When you live in hell on earth (aka Arizona) every degree helps lol. [IMG] tapatalkin
A "no coolant line" option would be sweet. tapatalkin
Out of curiosity, which controller are you using? tapatalkin
Figured it out.. the issue was caused by a ground that I forgot to solder. Soldered all other wires.. apparently forgot that one. tapatalkin
Power is delivered through the fan controller (assuming stock setup), id imagine. Is the temp sensor the same the reports temp back to the ap?...
Separate names with a comma.
