That's my plan. It is a daily driver. I swap between my MS3 and my Hemi powered Jeep Grand Cherokee. I'll just wait for the new ABS module. I...
I'm planning on replacing my front and rear brake pads and rotors soon. They front brake pads have been recently replaced but it was before I...
I would just like to post an update. I replaced #2 injector, all injector seals, and the intake manifold gasket. I went with graveyard performance...
I drove the car into work and only let it set for about an hour or two before doing the compression test. So the engine wasn't entirely cold.
Does any happen to know what compression is supposed to be for the 2.3l? I have access to alldata and they say it should be between 130psi and...
I verified the purge solenoid was commanded to 0% and removed the line from the purge solenoid to the fuel tank. The purge solenoid does not...
So here’s a little update after my 40 min drive home. My downstream o2 sensor woke up at some point and started reading. I didn’t notice that...
Just checked the AFR. It appeared to fluctuate although the scan tool used 1 in place of 14.7. On accel it read under 1 (around .87) and on decel...
I checked the gap on the old spark plugs. All were between .024 and .025. I replaced them with the NGKs. The gap on the new plugs is between .026...
I will check the spark plug gap tomorrow when I’m at work and I will report my findings. I also have some brand new ngks that I’ll double check...
Year/Make/Model: 2011 Mazdaspeed3 Mileage: 94k Location: GA Concern: CEL, Stutter under heavy acceleration DTC's: p0302 and p0171 Modifications:...
Separate names with a comma.