Recent Content by GohanX

  1. GohanX
    Post

    Dipstick direction?

    I have noticed on both my MS6 and my old Miata that the front and the back of the dipstick have a little variance for some weird reason. I'm not...
    Post by: GohanX, Dec 7, 2021 in forum: Mazdaspeed 3/6 Engine
  2. GohanX
    Post

    Best Jacks?

    When my 6 was lowered I had to be a bit creative, even with the lower profile jack my dad had it was too low. I'd usually end up using the...
    Post by: GohanX, Oct 4, 2021 in forum: Mazdaspeed 3 General Discussion
  3. GohanX
    Post

    Upgraded TMIC or downpipe?

    I'm a little late to the convo, but I have this exact setup, a Corksport TMIC, stock downpipe, second cat replaced by a Corksport race pipe. The...
    Post by: GohanX, Jul 22, 2021 in forum: Mazdaspeed 6 General Discussion
  4. GohanX
    Post

    Raising a lowered suspension?

    Those coils seem really compressed, I wonder if those are stock springs that have just sagged to the point of near failure. They look a little too...
    Post by: GohanX, Jul 22, 2021 in forum: Mazdaspeed 6 Suspension & Brakes
  5. GohanX
    Post

    How-to: Mazdaspeed 3 Mazdaspeed 6 Pivot Shaft Seal, Bearing, Breather Replacement

    Yeah on my 6 I put a jack with a block of wood under there to support it and took the whole mount off.
    Post by: GohanX, Jun 25, 2021 in forum: Mazdaspeed 3 How-To
  6. GohanX
    Post

    In tank fuel pump replacement

    I have a DeatschWerks DW65c in my 6. I only got it over the stock pump because I had Prime and Amazon got it to me much faster than the dealer...
    Post by: GohanX, Jun 19, 2021 in forum: Mazdaspeed 3 General Discussion
  7. GohanX
    Post

    Draining fuel from tank

    Yeah, it's under the back seat. The seat is just held on by clips, you literally just pull up on the fronts and there are a couple of metal plates...
    Post by: GohanX, Mar 19, 2021 in forum: Mazdaspeed 6 General Discussion
  8. GohanX
    Post

    Injector Seal Replacement Question

    Awafrican covered it already, but the hardest thing is getting those torx bolts off. I cannot stress enough how important it is to have a good...
    Post by: GohanX, Mar 17, 2021 in forum: Mazdaspeed 3 General Discussion
  9. GohanX
    Post

    Rear jack points?

    Jack at the diff itself, put stands at the rear of the frame rails. You'll need to jack up the front too and put it on stands as you need the car...
    Post by: GohanX, Mar 15, 2021 in forum: Mazdaspeed 6 General Discussion
  10. GohanX
    Post

    OEM EBCS vs aftermarket

    Awafrican knows how to party.
    Post by: GohanX, Mar 5, 2021 in forum: Mazdaspeed 3 General Discussion
  11. GohanX
    Post

    OEM EBCS vs aftermarket

    Maybe just a little.
    Post by: GohanX, Mar 2, 2021 in forum: Mazdaspeed 3 General Discussion
  12. GohanX
    Post

    To good not to share

    I'm not nearly a talented enough photographer to really capture it, unfortunately. It really takes a lot of sunlight to see the best in it, but at...
    Post by: GohanX, Feb 18, 2021 in forum: Mazdaspeed 6 General Discussion
  13. GohanX
    Post

    To good not to share

    Oh yeah, a good paint restoration should help. At the start of the quarantine last year I got a DA polisher and did a multi step paint restoration...
    Post by: GohanX, Feb 17, 2021 in forum: Mazdaspeed 6 General Discussion