Big sad.
At the end of it all. This engine is fucked and the project has to be dead to me, unfortunately. I've spent more money than I ever should have on...
I sent the head off to get pressure tested and resurfaced so confident the head is fine. But for the block. I didn't check it properly, I am...
The more I think about it the more I wonder if I just have a warped block or something.
I don't know exactly where it's leaking from yet. Just know that it still is. So I have to wonder immediately did I put the head gasket on wrong...
Anybody here wanna buy an 07 mazdaspeed6 with 135kish miles :sweatsmile::sob::sob:
So I tried something for shits and giggles ab 30 mins ago and I was finally able to get the car to start. Put the old camshaft position sensor...
Thanks again everyone! Will be spending the rest of this week going over every single wire I can find. Will verify everything advised here in the...
I currently have the radio and center console stuff out of the vehicle as I was planning to put aftermarket radio in. Is there any sort of like...
I don’t have spark on any of them. Tested this evening. I couldn’t confirm where that wire was going to today though. I have a general idea where...
Yessir I used a spark tester. I definitely haven't checked them all, only one so far. I'll get the others tested and see what I have. That wire...
The only thing that I have done is got the timing set, fixed those two ground wires, and then put back together. Tried to start the car after I...
Appreciate you fellas. I'll fuck with the ECU cables and stuff and just verify all of those look good. What're the chances that the ECU itself is...
@Rokusek @Easter Bunny Getting OBD B1342 code now. Assuming that the ECU is bad. Is buying a used one acceptable or what is your recommendation?...
Alright I’m back. Timing is 100% correct. Now my issue is I am not getting spark. All my grounds are in place and have repaired two of them but...
Separate names with a comma.
