Recent Content by Wilner John Agpaoa

  1. Wilner John Agpaoa
    Post

    Custom 1/2" ARP headstuds

    Sorry to bring this thread back from the dead but from the Mazworx website it says this HS is good anything over 600whp, I also read your post...
    Post by: Wilner John Agpaoa, Nov 7, 2023 in forum: Mazdaspeed 3/6 Engine
  2. Wilner John Agpaoa
    Post

    Cheap drop in build

    This is awesome! I read it a few times and also gathered half of the parts that I've seen here. Ive been searching what are the procedures for a...
    Post by: Wilner John Agpaoa, May 11, 2023 in forum: Mazdaspeed 3 Build Diaries
  3. Wilner John Agpaoa
    Post

    Mastermind's Build

    Was also wondering what you did with this cap ? Mine just came in today and some parts came with it that i do not know lol. Got everything pieced...
    Post by: Wilner John Agpaoa, Jul 24, 2018 in forum: Mazdaspeed 3 Build Diaries
  4. Wilner John Agpaoa
    Post

    DIY Port injection set up

    H Hey man, I was wondering why is the left side of the PI rail blocked but the diagram/drawing you attached to one of the posts above is that a...
    Post by: Wilner John Agpaoa, May 29, 2018 in forum: Mazdaspeed 3/6 Fuel, NOS, Meth, & Water Injection
  5. Wilner John Agpaoa
    Post

    Mastermind's Build

    @Mastermind46 do you mind sharing how you did the fuel lines for the port injection kit?
    Post by: Wilner John Agpaoa, Feb 11, 2018 in forum: Mazdaspeed 3 Build Diaries