I now see I posted fronts and you were looking for rears. Think I overlooked that as only in title. I bought the DTA fronts but I too now need...
I'm installing hitch on my ms6 for bike rack. Hitch is 24775 (Draw-Tite) made for Mazda6. Going off pics from thread knew the brackets that bolt...
I've copper coated oem and reused a number of times. Ya Im cheap but has worked fine for me and would do before using AM. Appreciate how you took...
Wow. I did a how to remove engine on MSF and well this How To puts that to shame. Im pulling my engine and know it would be a good time to be...
Denso 1976040 Mass AIR Flow Sensor works and im 99% sure its OEM. For $70 its a steal and just fixed my car with one sold by West Side Parts:...
I'm surprised they have not made subframe bushings given AFAIK you can't even buy them.
Happen to have specs?
This part confuses me but think maybe ment would work? If can find socket deep enough to clear shaft I would think this should work especially if...
What is OD of shaft? Can you count teeth? I wonder if another tool exists with same specs like these for example for Jeep I count 24 teeth on...
On MSF these were highly recommended at least for ms3 (I now see this is already in OP but new link below) and here thread on this forum:...
Well could have bought cheap 6203 bearings and spent $10 or so but the 6203lax30 could not find or determine what to go with so spent $40 on Gates...
Just drove car 30mi and drives much better. Back on ramps [ATTACH] Going to drain oil, fill with Kirkland 5w30 and drive for 100mi-1000mi? Before...
Took off TB to access starter solenoid wire that is again causing me issues: [ATTACH] Removed white plastic cover and cleaned wire connector, pin...
I assume that price included new/used headlight housings but I just used ones on car and bought TSX projectors on ebay for about $100 and...
IDK rules on linking other forums here but its same as mazda6 so here is old thread...
Going to take some time to figure out what you need. Havent used book in a while. But here is a start.
I'm not sure this makes sense. You just might not mean pi fuel pressure?
I have the schematic book. At some point can try to help and post pics of what need.
Well got nearly 180psi on #4 now. This is after revving engine other day (nothing more). Got sick past 3 days so just now got to retest. Was going...
Started up and running fine at idle. Sounded good. Rattle gone from tensioner that started this whole thing. As writing this came up to temp and...
Separate names with a comma.